Installation | <ENGLISH> |
Installing the Steering Remote Control Unit
<ENGLISH>
Installing the power box (Fig. 12)
The power box has velcro tape on the underside to secure it to the car mat.
• Wipe the surface thoroughly before affixing the velcro tape.
Velcro tape
Car mat
Fig. 12
About the fixing screws for the front panel (Fig. 13)
If you do not operate the Detaching and Replacing the Front Panel Function, use the sup- plied fixing screws and fix the front panel to this unit.
WARNING
•Avoid installing this unit in such a location where the operation of safety devices such as airbags is prevented by this unit. Otherwise, there is a danger of a fatal accident.
•Avoid installing this unit in such a location where the operation of the steering wheel and the gearshift lever may be prevented. Otherwise, it may result in a traffic accident.
CAUTION
•Installation of this unit requires specialized skills and experience. Installation of this unit should be entrusted to a dealer from whom you purchased this unit.
•Install this unit using only the parts supplied with this unit. If other parts are used, this unit may be damaged or could dismount itself, which leads to an accident or trouble.
•Install this unit as required by this manual. Failure to do so may cause an accident.
•Do not install this unit near the doors where rain- water is likely to be spilled on the unit. Incursion of water into the unit may cause smoke or fire.
WARNING
•Fix this unit securely to the steering wheel with the belt attached to the unit. If this unit is loose, it dis- turbs driving stability, which may result in a traffic accident.
•Do not attach this unit to the outer circumference of the steering wheel. Otherwise, it disturbs dri- ving stability, causing a traffic accident. Always attach this unit to the inner circumference of the steering wheel as shown. (Fig. 14)
Note:
•Do not install this unit in such a place as may obstruct the driver’s view.
•Since interior layout differs depending on the type of vehicle, the ideal installation location for the unit also differs. When installing the unit, select a location that assures optimum transmission of sig- nals from the unit to the car stereo.
Installing the Unit on a Left-Hand- Drive Car
Note:
•When the unit is installed on a
1.Secure inner holder to the inner cir- cumference of the steering wheel with belt. (Fig. 15)
•Fit the inner holder to the steering wheel so that the
Inner holder
Belt
Fig. 15
2.Cut the extra portion of the belt at the center of the inner holder. (Fig. 16)
3.Install outer holder on the inner holder and secure with screws. (Fig. 17)
•Tighten the screws with the supplied hexago- nal wrench.
Screw
Outer holder
Fig. 17
4.Install the remote control unit in the holder. (Fig. 18)
•When removing the remote control unit from the holder, move the corrugated release sec- tion toward the steering wheel and slide the remote control unit toward you.
Fixing screw
Fig. 13
Fig. 14
Fig. 16
Release Section
Fig. 18