INSTALLATION
4) SECURING THE BARBECUE
To secure the barbecue to the worktop the fastening clamps accompanying this booklet must be assembled. The following procedures must be carried out to do this:
remove all movable parts from the barbecue; turn the appliance over taking care to place it
on a soft surface to avoid damaging the external surfaces;
remove the clamps "G" from the package and install them according to the diagram in fig. 4.
After these steps have been carried out, the special gasket that prevents liquids from leaking can be installed. To fit this gasket correctly, please strictly follow the directions below:
-detach the gasket strips from their support taking care that the transparent protection remains attached to the gasket;
-put the gasket "E" (fig. 4) in the correct position under the edge of the table top, so that the outer side of the gasket fits perfectly with the external perimeter of the worktop. The ends of the strips must fit without overlapping;
-make sure the gasket adheres to the countertop evenly all around, press it down with your fingers, then remove the protective strip of the gasket and position the barbecue in the opening made in the worktop;
-secure the appliance by tightening the clamp screws "F" (see fig. 5).
-In order to prevent any accidental contact with the surface of the heated barbecue during use, a separation in wood must be inserted and fastened with screws at a minimum distance of 60 mm from the top (fig. 6).
WARNING: Note that the adhesive which joins the plastic laminate to the worktop must be resistant to temperatures of no less than 150°C to prevent the covering from detaching.
The installer is advised that the rear wall, adjoining and surrounding surfaces of the barbecue must be resistant to a temperature of 75K.
USEFUL MEASUREMENTS
(mm)
| A | B | C | D | E |
BARBECUE | 285 | 485 | 60 | 60 | 150 min. |
|
|
|
|
|
|
|
|
|
FIG. 4 | FIG. 5 | FIG. 6 |
|
|
|
19