Weber Weber Liquid Propane Gas manual Install the left end trim piece and swing-up work, Surface

To raise swing-up work surface: Lift table all the way	Install the left end trim piece and swing-up work
up and slide it to the left, then lower table until you feel	surface
it lock in the up position.	You will need: End trim piece, swing-up work surface,
	swing-up work surface rod, two 1/2 inch bolts, two
To lower swing-up work surface: Lift table up until it	nylon washers and a wrench
disengages and slide it to the right. Then lower it all	1.) Start the left end trim piece into the frame as
the way down so that the locking pin on the right side	shown, do not push the trim piece in all of the
of the table fits into the locking bracket on the leg,	way and do not add bolts yet.
which will secure the table in the down position.
Do not use the swing-up work surface as a cutting
board.

2.) Slide the swing-up work surface rod through the holes at the top of the swing-up work surface.

3.) Insert one end of the swing-up work surface rod into the hole in the frame.

C-3