c)Connect the hose to the tank. Route the hose so it does not interfere with the scale indicator rod. Slide back the collar of the quick disconnect on the tank valve. Figure 5 (a). Push the male fitting of the regulator into the quick disconnect, and maintain pressure. Slide the collar closed. Figure 5 (b). If it does not engage or lock, repeat procedure. Gas will not flow unless the quick disconnect is properly engaged.
(a)
Male fitting
Regulator
Collar
(b)
Quick disconnect
Figure 5 engaged
d)Mix soap and water.
e)Open the tank valve. Figure 6.
Figure 6
f)Check for leaks by wetting the fitting with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak.
If there is a leak turn off the gas, tighten the fitting, turn the gas back on and recheck with the soap and water solution.
If leak does not stop, turn off the gas and contact
g)When leak checks are complete, turn gas supply OFF and rinse connections with water.
LP Tank
The LP tank manufacturer is responsible for the materials, workmanship and performance of the tank. If the tank has a defect, malfunctions, or you have a question regarding the tank, call the tank manufacturer's customer service center. The phone number is on the warning decal which is permanently attached to the tank. If the tank manufacturer has not resolved the issue to your satisfaction, then call
25