Weber 55258 Connection. Using a wrench could damage, Regulator coupling and could cause a leak

Gas Instructions

We utilize various LP tank manufacturers. Some of the	Note: This is a new type of connection. It tightens clockwise
	and will not allow gas to flow unless the connection is tight.
tanks have differing top collar assembles. (The top collar
	The connection requires tightening by hand only.
is the metal protective ring around the valve.) One series
	WARNING: Do not use a wrench to tighten the
of tanks mount with the valve facing front. The other tanks
	connection. Using a wrench could damage the
mount with the valve facing away from the fuel scale.
	regulator coupling and could cause a leak.
These types of tanks are illustrated below.
	5) Mix soap and water.
You will need: LP cylinder, a soap and water solution and a
rag or brush to apply it.
1) Turn the LP cylinder so the opening of the valve is
either to the front, side or rear of the Weber® gas
barbecue. Lift and hook the cylinder onto the fuel
gauge.

	6)	Turn on the cylinder valve.
	7)	Check for leaks by wetting the fitting with the soap and
		water solution and watching for bubbles. If bubbles
		form, or if a bubble grows, there is a leak.
	If there is a leak, turn off the gas and tighten the fitting. Turn
2) Loosen the cylinder lock wing nut. Swing the cylinder	the gas back on and recheck with the soap and water
	solution.
lock down. Tighten the wing nut.	If leak does not stop, Contact the Customer Service
	Representative in your region using the contact information
	sheet provided with your manual. Do not use the barbecue.
	8)	When leak checking is complete, turn gas supply OFF
		at the source and rinse connections with water.

To Connect the hose to the cylinder:

3)Remove the plastic dust cover from the valve.

4)Screw the regulator coupling onto the tank valve, clockwise, or to the right. Hand-tighten only.

CC--2