Weber 55258 manual Remove control panel and burner control knobs, Checking

Page 22

Gas Instructions

Check for gas leaks

Remove control panel and burner control knobs

After a period of nonuse, we recommend that you perform

You will need: Phillips screwdriver.

1) Remove control knobs.

the following maintenance procedures for your safety.

2) Remove screws through slots in trim with a Phillips

WARNING: Check the hose before each use of the

screwdriver.

barbecue for nicks, cracking, abrasions or cuts. If

3) Pull up igniter button until it sticks in the up position

the hose is found to be damaged in any way, do not

and remove control panel from grill.

use the barbecue. Replace using only Weber

 

authorized replacement hose. Contact the

(1)

Customer Service Representative in your region

 

using the contact information sheet provided with

 

your manual.

 

Inspect the burners for correct flame pattern. Clean if

 

necessary, following the procedures outlined in the

 

“General Maintenance” section of this manual.

 

Check all gas fittings for leaks.

 

DANGER

 

Do not use an open flame to check for gas

(2)

leaks. Be sure there are no sparks or open

 

flames in the area while you check for leaks.

(3)

Sparks or flames will result in a fire or

 

explosion, which can cause serious bodily

 

injury or death, and damage to property.

 

WARNING: You should check for gas leaks every

 

time you disconnect and reconnect a gas fitting.

 

Note - All factory-made connections have been thoroughly

4) Replace control panel when Leak Check is completed.

checked for gas leaks. The burners have been flame

 

tested. As a safety precaution however, you should

 

recheck all fittings for leaks before using your Weber® gas

 

barbecue. Shipping and handling may have loosened or

 

damaged a gas fitting.

 

WARNING: Perform these leak checks even if your

 

barbecue was dealer- or store-assembled.

 

You will need: a soap and water solution and a rag or

 

brush to apply it.

 

To perform leak checks: Make sure all Burners are in the

 

off position. Turn on gas supply.

 

WARNING: Do not ignite burners while leak

 

checking.

 

Check for leaks by wetting the connections with the soap

 

and water solution and watching for bubbles. If bubbles

 

form, or if a bubble grows, there is a leak.

 

CC--3

Image 22
Contents N E S I S LP Gas Grill Owners GuideLiquid Propane GAS Units only Contents Warranty USAGeneral Instructions Storage and/or NonuseCleaning CookingExploded View Exploded View List Parts List Unpacking Ba201.d Page Page B205LP.b Page Page Page 1011 Page Gas Instructions Regulator coupling and could cause a leak Connection. Using a wrench could damageTo Connect the hose to the cylinder Barbecue for nicks, cracking, abrasions or cuts. If Use the barbecue. Replace using only WeberRemove control panel and burner control knobs Hose is found to be damaged in any way, do notRepresentative in your region using the contact Customer Service Representative in your region usingGRILL. Contact the Customer Service Attendant, who fills the cylinder by weightRegion using the contact information sheet provided Attendant, who fills the tank by weight. ImproperContact the Customer Service Representative in your Cylinder valve before disconnectingLighting Operating InstructionsTo Extinguish Manual Lighting Troubleshooting Problem Check CureMain Burner Cleaning Procedure MaintenanceAnnual Maintenance Weber Spider /Insect screensReplacing Main Burners Crossover Ignition System Operations