Weber 55553 manual Check for gas leaks, Remove control panel and burner control knobs

Page 22

Gas Instructions

Remove control panel and burner control knobs

You will need: Phillips screwdriver.

1)Remove control knobs.

2)Unhook side burner from Cookbox Frame.

3)Remove screws with a Phillips screwdriver

4)Pull up igniter button until it sticks in the up position and remove control panel from grill.

5)Replace control panel when Leak Check is completed.

(1)

(2)

(4)

(3)

Check for gas leaks

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause serious bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may loosen or damage a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution, and a rag or brush to apply it.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Make sure side burner is OFF.

To perform leak checks: open cylinder valve by turning the cylinder valve hand-wheel counterclockwise.

WARNING: Do not ignite burners when leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.

C-3

Image 22
Contents N E S I S LP Gas Grill Owner’s GuideLiquid Propane GAS Units only Contents Warranty Customer Service Center Roselle Road, Suite Schaumburg, ILStorage and/or Nonuse For Installation in CanadaGeneral Instructions OperatingCleaning CookingExploded View Exploded View List Parts List Unpacking Ba301.a Page Page B302LP.b Page Page Page Page Page Leaks. Be sure there are no sparks or open Connecting the Liquid Propane CylinderDo not use an open flame to check for gas Flames in the area while you check for leaksTo Connect the hose to the cylinder Check for gas leaks Remove control panel and burner control knobsRemoval of the LP cylinder Liquid Propane Cylinder requirements Safe handling tips for Liquid Propane GasCylinders For Canada onlyLighting Operating InstructionsTo Extinguish Manual Lighting Gas to clear if the side burner does not light Failure to open the lid while igniting the sideBurner, or not waiting 5 minutes to allow On a bright sunny dayTroubleshooting Problem Check CureFlame is very yellow Side Burner TroubleshootingConjunction with the smell of gas Main Burner Cleaning Procedure MaintenanceAnnual Maintenance Weber Spider /Insect screensReplacing Main Burners Crossover Ignition System Operations