CHECK FOR GAS LEAKS (CONTINUED)
mDANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death and damage to property.
mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.
You will need: a soap and water solution and a rag or brush to apply it.
Turn on gas supply.
Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak.
Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.
mWARNING: Do not ignite burners when leak checking.
Check:
a)Left valves to manifold connection. Figure 20 (a).
b)Center valves to manifold connection. Figure 20 (b).
c)Right valves to manifold connection. Figure 20 (c).
d)Hose to manifold connection. Figure 20 (d)
mWARNING: If there is a leak at connection 20 (d) turn OFF the gas and retighten the fitting with a wrench and recheck for leaks with soap and water solution.
If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact your dealer.
a)
c)
Manifold 
Summit 400
d)
Summit 600
Manifold
a)
c)
b) 
Manifold
Manifold
Figure 20
10