Weber D4, D6 manual MAINTENANCE27, Crossover Ignition System Operations, Replace Igniter Batteries

Page 27

MAINTENANCE27

15.To reinstall the manifold assembly, reverse steps 7 through 14.

CAUTION: The burner openings (1) must be positioned properly over the valve orifices (2).

(2)

(1)

Check proper assembly before fastening manifold in place.

WARNING: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the grill. (See, “Check for gas leaks.”)

CROSSOVER® IGNITION SYSTEM OPERATIONS

If the Crossover ignition system fails to ignite the LEFT burner in a burner set, light the LEFT burner with a match. If the LEFT burner lights with a match, then check the Crossover® ignition system.

Check that both ignition wires(1,2) are attached properly.

Check that the Crossover® ignition button is activating.

You should hear the igniter sparking.

If the Crossover® ignition system still fails to light, contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

(1)

(2)

REPLACE IGNITER BATTERIES

Parts required: 1 AA alkaline battery per igniter.

Unscrew igniter button from top of control panel. Remove igniter button and contact spring. Remove old battery and replace with a new AA alkaline battery. Positive end(1) of battery faces up as shown in illustration. Replace spring contact(2) and screw igniter button(3) back down.

Image 27
Contents BUILT-IN NG GAS Grill Owners Guide Summit #Liquid Propane GAS Units only WARRANTY3 WarrantyStorage Operating GAS Supply Testing General InstructionsGrilling Methods Cleaning GAS Instructions Check for GAS LeaksRemove Control Panel GAS Instructions Check Reinstall Control Panel Operating Instructions Direct CookingFlavorizer system Grilling Tips & Helpful Hints Indirect CookingLighting Crossover Ignition SystemTo Extinguish Manual Lighting Using the Smoker Cleaning the smokerTo use the smoker Lighting the Smoker Burner Manually Lighting the Smoker Burner Insert the rotisserie shaft in the motor Rotisserie AssemblyInstall the motor bracket Put the spit forks on the rotisserie shaftCooking Using the RotisserieImportant Safeguards OperatingLighting Rotisserie Burner Lighting the Rotisserie BurnerManually Lighting the Rotisserie Burner Problem Check Cure Main & Smoker Burner TroubleshootingBurner does not light Rotisserie TroubleshootingMain Burner Flame Pattern MAINTENANCE23Main Burner Cleaning Procedure Weber Spider /INSECT ScreensReplace Main Burners 24MAINTENANCEMAINTENANCE25 BB 26MAINTENANCEMAINTENANCE27 Crossover Ignition System OperationsReplace Igniter Batteries WEBER-STEPHEN Products CO
Related manuals
Manual 28 pages 28.64 Kb