Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 28.
Notch to the front
Slide bar
View from front of barbecue
Step 22
Complete accessory installation
You will need: two work tables, two accessory trays, Warm- Up Basket, warming rack, thermometer, three tubing plugs and a hammer.
Insert one end of the Weber
Set the work tables onto the left and right side rails. Figure 30 (b).
Set the accessory trays between the two frame connectors. Figure 30 (c).
Set the warming rack into the slots at the rear of the cooking box. Figure 30 (d).
Insert the thermometer into its holder. Figure 30 (e). Insert tubing plugs into the ends of the frame. To fully seat the plugs, you may have to tap them lightly with a hammer. Figure 30 (f).
Figure 28
(a)
To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 29.
(d)
(b)
(e)
(b)
(f)
Support rod
View from rear of barbecue
Slide
Unlocked position | Locked position |
Figure 29
(c)
Figure 30
mCAUTION: To keep the barbecue stationary, the tabs on the locking casters should be in the down position.
21