Weber 2000 Series, 98615 owner manual Manual Lighting

Page 23

Manual Lighting

mDANGER

Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame- up which can cause serious bodily injury or death.

1)Open the lid. Figure 2.

2)Check that fuel scale reads more than “E”. Note - E = empty; F = full.

3)Make sure all burner control knobs are turned OFF. (Push each burner control knob down and turn clockwise.)

mWARNING: The burner control knobs must be in the

OFF position before turning on the LP tank valve. If they are not in the OFF position, when you turn on the LP tank valve, the excess flow control will activate, limiting the flow of gas from the LP tank. If this should occur, turn OFF the LP tank valve and burner control knobs and start over.

mDANGER

When the excess flow control is activated, a small amount of gas is still flowing to the burners. After turning OFF the tank and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive flame- up which can cause serious bodily injury or death.

1

 

Manual Lighting

 

3

 

8

7

4

 

5

2

6

Figure 2

4)Turn the tank on by turning the tank valve counterclockwise.

5)Strike a match and put the flame into the matchlight hole in the front of the cooking box.

mWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.

6)Push Front burner control knob down and turn to START/HI.

7)Check that the burner is lit by looking through the matchlight hole on the front of the cooking box.

mWARNING: If the burner does not light, turn the Front burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

8)After the FRONT burner is lit you can turn on the other burners.

Note - Always light the FRONT burner first. The other burners ignite from the FRONT burner.

To Extinguish

Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF.

23

Image 23
Contents Genesis 2000 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageStep AssemblyCheck package contents BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsInsert casters Continue frame assemblyComplete frame assembly Add cooking box Install tank panel assembly Install manifold bracketAdd fuel scale Install igniterFill LP tank Set LP fuel scaleConnect LP tank Check that the burner valves are offCheck for gas leaks Install the bottom tray Install Flavorizer Bars and Cooking GratesInstall tool holders, control panel and burner control knobs Install the lidInstall swing table Complete accessory installation To Extinguish LightingManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankMale fitting Regulator DOT 4BA240 Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMain Burner Cleaning ProcedureSee Section Weber Spider Stopper GuardsTo reinstall burners, reverse steps c through g Crossover Ignition System Operations Troubleshooting Page 10-11 Parts List Final Word of Thanks