Weber S-660TM, S-460TM manual 16ASSEMBLY

Page 16

16ASSEMBLY

18

ATTENTION! Before drilling any holes for the rear vent make sure the cookbox is flush with the front of the grill frame.

1/4" (6.35 mm) Drill Bit

WWW.WEBER.COM®

Image 16
Contents GAS Grill 2WARNINGS BUILT-IN Cutout DimensionsClearances Dimensions BUILT-IN Cutout Dimensions BUILT-IN Cutout DimensionsTolerances Parts List Parts List Assembly ASSEMBLY7 8ASSEMBLY Assembly Inch overhang. Notch front edge for frame to fully slide 6.35 mm Drill Bit Battery Housing Wiring ASSEMBLY13 14ASSEMBLY 460 660 16ASSEMBLY ASSEMBLY17 460 660 460 660 Assembly ASSEMBLY21 General Specifications for Piping GAS SupplyBUILT-IN GAS Line Locations BUILT-IN GAS Line LocationsGAS Supply Test ConnectionsTypical 20 LP Propane GAS Supply Installation BUILT-IN Tank Enclosure Instructions OperatingLocating Your LP Tank Enclosure KIT Enclosure ChartClearance from Combustible Surfaces or Structures Parts List / Assembly Parts List28ASSEMBLY Mounting the LP Tank BracketConnection Chart Connect GAS SupplyVentilation Page WEBER-STEPHEN Products CO