Weber Silver C Install manifold brackets, Install cylinder panel, Frame brace2, Add fuel gauge

Page 14

Install manifold brackets

The manifold brackets(2) are already in place on the manifold between the valves.

Place your hand underneath the manifold. Lift the manifold and cooking box slightly and hook the manifold bracket(2) onto the frame brace(1).

(1)(2)

Install cylinder panel

You will need: Cylinder panel, two 1 3/4inch bolts, two nylon cylinder glides, two nylon washers a 7/16 inch or adjustable wrench and pliers.

Insert the cylinder panel tabs(1) into the slots in the

frame brace(2).

(2)

(1)

Slide the cylinder panel up until notch at bottom of panel fits over the cross brace(1). Add nylon washer to bolt and insert through the hole in the wheel frame at the bottom right of the cylinder panel, make sure that the bolt slips through the hole in the cylinder panel. Add nylon cylinder glide to bolt end and tighten bolt with the wrench, while holding the cylinder glide with the pliers. Repeat procedure with the hole on the bottom left side of the cylinder panel.

(1)

Add fuel gauge

You will need: fuel gauge, two wing nuts and two nylon washers.

1)Slip the bolts on the back of the fuel gauge through the two small holes in the cylinder panel.

2)Add washers to the bolts, then wing nuts, and tighten with your fingers.

(1)

(2)

B-4

Image 14
Contents Owners Guide Liquid Propane GAS Units only Warranty Customer Service Center Roselle Road, Suite Schaumburg, ILContents Operating For Installation in CanadaStorage Genesis Silver-C LP Manifold, Hose and regulator assembled Page Page Page Assemble wheel frame Assemble frameAdd front panel Continue frame assemblyComplete frame assembly Add back panelAdd cooking box assembly Insert castersFrame brace2 Install manifold bracketsInstall cylinder panel Add fuel gaugeCheck that all burner valves are off Install igniterInstall the slide out bottom tray Install Lid Installing Features Do not use the work surface as a cutting board Install the work surface Install side burnerInstalling the warming rack Installing the Warm-Up BasketInstall the thermometer Install the bottom shelfChecking the fuel level in your tank Fill liquid propane cylinderTo Connect the hose to the cylinder Check for gas leaks Lighting To ExtinguishManual Lighting Lighting the Side Burner Lighting only the side burnerStorage and/or Nonuse CleaningCooking Important LP Cylinder Information Refilling the Liquid Propane CylinderRemoval of the LP cylinder Liquid Propane Cylinder Liquid Propane LP Cylinders Safe handling tips for Liquid Propane Gas CylindersFor Canada Only Liquid Propane Cylinder requirementsAnnual Maintenance CheckWeber Spider /Insect screens General MaintenanceMain Burner Cleaning Procedure Main Burner Flame PatternReplacing Main Burners Crossover Ignition System Operations Burners burn with a yellow or Barbecue temperature onlyFlame is low when burner is on Orange flame, in conjunction withFlame is very yellow Side Burner does not lightFlame is low in High position Conjunction with the smell of gasSee Section a See Section B Install manifold bracketWeber Spider Stopper Guards See Section D