Weber Silver C manual General Maintenance, Weber Spider /Insect screens, Main Burner Flame Pattern

Page 32

General Maintenance

Weber Spider /Insect screens

Your Weber Gas Barbecue, as well as any outdoor gas appliance, is a target for spiders and other insects. They can nest in the venturi section(1) of the burner tubes. This blocks the normal gas flow, and can cause the gas to flow back out of the air shutter. This could result in a fire in and around the air shutters, under the control panel, causing serious damage to your barbecue.

(1)

The burner tube air shutter is fitted with a stainless steel screen(1) to prevent spiders and other insects access to the burner tubes through the air shutter openings.

(1)

We recommend that you inspect the Spider/Insect screens at least once a year. (See Section “Annual Maintenance”.) Also inspect and clean the the Spider/Insect screens if any of the following symptoms should ever occur:

1)The smell of gas in conjunction with the burner flames appearing yellow and lazy.

2)Barbecue does not reach temperature.

3)Barbecue heats unevenly.

4)One or more of the burners do not ignite.

DANGER

Failure to correct the above mentioned symptoms may result in a fire, which can cause serious bodily injury or death, and cause damage to property.

Main Burner Flame Pattern

The Weber Gas Barbecue burners have been factory set for the correct air and gas mixture. The correct flame pattern is shown.

1)Burner tube

2)Tips occasionally flicker yellow

3)Light blue

4)Dark blue

(1)

(2)

(3)

(4)

If the flames do not appear to be uniform throughout the burner tube, follow the burner cleaning procedures.

Main Burner Cleaning Procedure

Turn off the gas supply. Remove the manifold. Look inside each burner with a flashlight.

Clean the inside of the burners with a wire (a straightened-out coat hanger will work). Check and clean the air shutter opening at the ends of the burners. Check and clean the valve orifices at the base of the valves. Use a brass bristle brush to clean outside of burners. This is to make sure all the burner ports are fully open.

CAUTION: Do not enlarge the burner ports when cleaning.

D-9

Image 32
Contents Owners Guide Liquid Propane GAS Units only Warranty Customer Service Center Roselle Road, Suite Schaumburg, ILContents Operating For Installation in CanadaStorage Genesis Silver-C LP Manifold, Hose and regulator assembled Page Page Page Assemble wheel frame Assemble frameContinue frame assembly Complete frame assemblyAdd front panel Add back panelAdd cooking box assembly Insert castersInstall manifold brackets Install cylinder panelFrame brace2 Add fuel gaugeCheck that all burner valves are off Install igniterInstall the slide out bottom tray Install Lid Installing Features Do not use the work surface as a cutting board Install the work surface Install side burnerInstalling the warming rack Installing the Warm-Up BasketInstall the thermometer Install the bottom shelfChecking the fuel level in your tank Fill liquid propane cylinderTo Connect the hose to the cylinder Check for gas leaks Lighting To ExtinguishManual Lighting Lighting the Side Burner Lighting only the side burnerStorage and/or Nonuse CleaningCooking Important LP Cylinder Information Refilling the Liquid Propane CylinderRemoval of the LP cylinder Liquid Propane Cylinder Safe handling tips for Liquid Propane Gas Cylinders For Canada OnlyLiquid Propane LP Cylinders Liquid Propane Cylinder requirementsAnnual Maintenance CheckGeneral Maintenance Main Burner Cleaning ProcedureWeber Spider /Insect screens Main Burner Flame PatternReplacing Main Burners Crossover Ignition System Operations Barbecue temperature only Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction withSide Burner does not light Flame is low in High positionFlame is very yellow Conjunction with the smell of gasSee Section B Install manifold bracket Weber Spider Stopper GuardsSee Section a See Section D