Weber Hose and Regulator Replacement, QCC1 Step, Reinstall control panel and burner control knobs

Page 15

Step 7

Reinstall control panel and burner control knobs

Follow Step 2 in reverse.

Step 8

Read and follow the Operating instructions in your Owner’s manual

In addition to the Lighting and Manual Lighting Sections in the Operating Instructions, the following Warning and Danger should be heeded after making sure the burner control knobs are turned OFF.

WARNING: The burner control knobs must be in the OFF position before turning on the LP tank valve. If they are not in the OFF position when you turn on the LP tank valve, the excess flow control will activate, limiting the flow of gas from the LP tank. If this should occur, turn OFF the LP tank valve and burner control knobs and start over.

DANGER

When the excess flow control is activated, a small amount of gas is still flowing to the burners. After turning OFF the tank and burner control knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive flame-up which can cause serious bodily injury or death.

Image 15
Contents QCC1 Hose and Regulator Replacement POL regulator Step Disconnect hose and regulator assembly from LP tankRemove burner control knobs and control panel CaseRemove hose and regulator assembly from manifold FlameCheck Safety System Attach new QCC1 hose and regulator assembly to manifoldConnect the QCC1 hose and regulator assembly to LP tank Check for gas leaks FlameCheck safety system If you have a more recent model, follow steps below Remove hose and regulator assembly from manifold Connection requires tightening by hand only Check for gas leaks Page Reinstall control panel and burner control knobs Regulador POL Si tiene un regulador POL PasoPaso 2 Caso CasoRetire del múltiple al ensamblaje de la manguera y regulador Paso 3 CasoSistema de seguridad FlameCheck Paso 4 CasoPaso 5 Caso Compruebe que no existan fugas de gas Paso 6 CasoSistema de seguridad FlameCheck Caso Paso 3 Caso Paso 5 Caso Compruebe de que no haya fugas de gas Page Siga el Paso 2 en reverso En convertissant votre barbecue avec Si vous possédez un régulateur POL ÉtapeÉtape 2 cas CasRetirez le boyau et le régulateur du collecteur Étape 3 casDispositif de sécurité FlameCheck Étape 4 casÉtape 5 cas Vérifiez pour voir s’il n’y a pas de fuites de gaz Étape 6 casDispositif de sécurité FlameCheck Cas Étape 3 cas Étape 5 cas Étape 6 cas Page Suivez les directives de l’étape 2 à l’envers 55354 04/03