Step 5 (Case 1)
Connect the QCC1 hose and regulator assembly to LP tank
WARNING: Make sure that the LP cylinder valve is closed. Close by turning valve clockwise.
Route the hose so it will not interfere with the tank scale indicator rod.
The hose and regulator are connected in the following manner:
1.Remove the plastic dust cover from the valve.
2.Screw the regulator coupling onto the tank valve, clockwise, or to the right.
Note: This is a new type of connection. It tightens clockwise and will not allow gas to flow unless the connection is tight. The connection requires tightening by hand only.
WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.
Indicator
rod
| Regulator |
E | hose |
F |
|
Screw coupling clockwise