Weber 3100 owner manual Secure side burner, MCAUTION Make sure both locks have snapped into place

Page 19

Step 19

Install tool holders, control panel and burner control knobs

You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.

Hook the tool holders over the frame rail. Figure 26.

Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 25 (a).

Push on the burner control knobs. Figure 25 (b).

Insert in frame brace

(a)

Crossover

Ignition

Button

Control panel

Phillips screws/

washers

(b)

Tool holders

Figure 25

Step 20

Secure side burner

Stand to the right side of the barbecue. Slightly pull back both side burner locks. Slide the side burner toward the control panel. The locks will snap into the slots in the front and back of the side burner. Figure 26.

mCAUTION: Make sure both locks have snapped into place.

View from top

Side view

Figure 26

19

Image 19

Contents Genesis 3100 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Storage For Installation in CanadaGas supply testing General InstructionsCheck package contents AssemblyStep BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsComplete frame assembly Continue frame assemblyInsert casters Add cooking box Install side burner locksTest connections Install gas supplyGeneral Specifications for Piping Gas line pipingConnect flexible hose to manifold Install igniter Check that all burner valves are offInstall manifold bracket Install side burnerMWARNING Make sure gas supply is OFF Death and damage to property Check for gas leaksMWARNING Do not ignite burners while leak checking Install Flavorizer Bars and Cooking Grates Install the lid Install the bottom trayMCAUTION Make sure both locks have snapped into place Secure side burnerInstall swing table Complete accessory installation To Extinguish LightingTurn gas supply OFF at the source, then push down Manual Lighting Lighting only the side burner. Figure Lighting the side burnerDrippings and grease Periodic CleaningCooking Storage and/or NonuseCast Iron Cooking Grates Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMain Burner Cleaning Procedure Weber Spider Stopper GuardsView from behind cooking box Wing nuts Crossover Ignition System Operations Burner flame pattern is erratic. Flame is low Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner TroubleshootingPage Use only Weber factory authorized parts. Parts List13,18 Final Word Thanks