Weber 38008 manual To Extinguish, Manual Lighting

Page 16

16

OPERATING INSTRUCTIONS

 

 

DANGER

When the “excess gas flow control” feature is activated, a small amount of gas is still flowing to the burners. After turning OFF the cylinder knobs, wait at least 5 minutes for the gas to clear before attempting to light the barbecue. Failure to do so may result in an explosive flame-up, which can cause serious bodily injury or death.

3)Turn the cylinder on by turning the cylinder valve counterclockwise.

WARNING: Do not lean over the open barbecue.

4)Select the burner set you want to operate.

5)Push LEFT burner control knob down and turn to START/HI in selected burner set.

6)Push igniter button and hold until burner ignites. You will hear the igniter sparking.

7)Check that the burner is lit by looking through the cooking grates. You should see a fl ame.

WARNING: If the burner does not light, turn the LEFT burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.

8)After the LEFT burner is lit you can turn on the RIGHT burner adjacent to it. The RIGHT burner lights from the LEFT burner.

MAIN BURNER LIGHTING

1

4,5,8

7

2

3 6

2

*The grill illustrated may have slight differences than the model purchased.

TO EXTINGUISH

Push down and turn each burner control knob clockwise to the OFF position. Turn gas supply OFF at the source.

MANUAL LIGHTING

DANGER

Failure to open the lid while igniting the barbecue’s burners, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flame-up which can cause serious bodily injury or death.

1)Open the lid.

2)Make sure all burner control knobs are turned OFF. (Push each knob down and turn clockwise to ensure they are in the off position.)

WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane cylinder valve. If they are not in the OFF position, when you turn on the LP cylinder valve, the “excess gas flow control” feature will activate, limiting the flow of gas from the LP cylinder. If this should occur, turn OFF the LP tank valve and burner control knobs. Then start over.

MAIN BURNER LIGHTING

1

4,5,7

6

2

3

2

*The grill illustrated may have slight differences than the model purchased.

Image 16
Contents Summit GAS Grill LP US EnglishLiquid Propane GAS Units only Customer Service Center Roselle Road, Suite Schaumburg, IL WarrantyFor replacement parts call For Installation in Canada General InstructionsStorage AND/OR Nonuse OperatingGrilling Methods Cleaning Connecting the Liquid Propane Cylinder Important LP Cylinder InformationCheck That ALL Burner Valves are OFF To Connect the hose to the cylinderGAS Instructions Check for GAS Leaks Remove Control PanelCheck for GAS Leaks Summit a Reinstall Control Panel Gold B4Refilling the Liquid Propane Cylinder Checking the Fuel Level in Your TankSafe Handling Tips for Liquid Propane GAS Cylinders Removal of the LP cylinderLiquid Propane Cylinder requirements Liquid Propane LP CylindersCanada Liquid Propane Cylinder requirements Direct Cooking Grilling Methods Flavorizer system Indirect Cooking Operating InstructionsGrilling Tips & Helpful Hints Lighting Crossover Ignition SystemTo Extinguish Manual LightingOperating Instructions Lighting only the side burner Side Burner Lighting InstructionsLighting the side burner if the main burners are lit Cleaning the smoker Using the SmokerTo use the smoker Lighting the Smoker Burner Manually Lighting the Smoker Burner Operating Instructions Rotisserie Assembly Install the motor bracketAttach the motor Put the spit forks on the rotisserie shaftUsing the Rotisserie Important Safeguards CookingLighting the Rotisserie Burner Lighting Rotisserie BurnerTo Extinguish Manually Lighting the Rotisserie Burner Operating Instructions Main and Smoker Troubleshooting Side Burner Troubleshooting Side Burner MaintenanceRotisserie Troubleshooting Maintenance Annual MaintenanceInspection and cleaning of the Spider/Insect screens Weber Spider /INSECT ScreensMain Burner Cleaning Procedure Main Burner Flame PatternReplace Main Burners Turn off the gas supplyMaintenance Maintenance Crossover Ignition System Operations Replace Igniter Batteries