MAINTENANCE
h)Lift and twist the burner assembly slightly, to separate the crossover tube from the burners. Figure 13. Remove the burners from the cooking box.
Crossover tube
Figure 13
i)To reinstall the burners, reverse steps c) through h).
mCAUTION: The burner openings must be positioned properly over the valve orifices. Figure 14 (a).
Check proper assembly before fastening manifold in place. Figure 14 (b).
(a)
Valve
Burner
(b)
Figure 14
j)Reinstall the Spider Stopper Guards. Slightly rotate the Spider Stopper Guards so that the seams are in line with the Venturi fins. There should be no gaps in the seams or in the fit around the burners and valves. Figure 15.
Check fit around valve
Venturi fin
Check fit around burner
Figure 15
mCAUTION: If the Spider Stopper Guards do not fit tightly, contact
mCAUTION: After reinstalling the gas lines, they should be leak checked with a soap and water solution before using the barbecue.
Crossover Ignition System Operations
If the Crossover Ignition System fails to ignite the Front burner, light the Front burner with a match. If the Front burner lights with a match, then check the Crossover Ignition System.
■Check that both the white and black ignition wires are attached properly. Figure 16.
■Check that the Crossover Ignition button pushes the igniter (button) down, and returns to the up position.
■Check to see if the igniter is loose in the frame. Tighten if necessary; See “Check That Items Are Secured” in the
If the Crossover Ignition System still fails to light, contact
White wire
Black wire
Figure 16
13