LIGHTING THE MAIN BURNERS
Summary lighting instructions are on the control panel.
mDANGER
Failure to open sliding work surfaces while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive
Crossover Ignition System
Note - The Crossover Ignition System ignites the Front burner with a spark from the igniter electrode inside the Gas Catcher Ignition Chamber. You generate the energy for the spark by pushing the Crossover Ignition Button until it clicks.
1 
2
7
6 5
4
3
mWARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Order from
1)Open the lid. Figure 1.
2)Make sure all burner control knobs are OFF. (Push each burner control knob down and turn clockwise.)
For barbecues equipped with a side burner, push the burner control knob in and turn clockwise to OFF.
3)Turn gas supply valve on.
mWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue.
4)Push Front burner control knob down and turn to START/HI.
5)Push the Crossover Ignition Button several times, so it clicks each time.
6)Check that the burner is lit by looking through the matchlight hole in the front of the cooking box. (For closed cart models, open the right door to access the matchlight hole.)
mWARNING: If the burner does not light, turn the
FRONT burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match.
7)After the FRONT burner is lit you can turn on the other burners.
Note - Always light the FRONT burner first. The other burners ignite from the FRONT burner.
| TO EXTINGUISH |
Figure 1 | Turn gas supply OFF at the source, then push down |
| and turn each burner control knob clockwise to OFF. |
6