Installing Work Surfaces, Side Burner
& Gas Connection Guidelines
Install Left Work Surface | Check that the side burner valve is in the OFF position. |
You will need left work surface, two 1/2 inch bolts, two | Push in and turn to OFF. |
nylon washers and a 7/16 inch or adjustable wrench. |
|
Insert the left work surface tabs in the slots in the |
|
frame(1). Slip washers on the bolts and insert the bolts |
|
as shown(2). Tighten |
|
(1)(2)
Install Side Burner Assembly
You will need side burner assembly (assembly in- cludes mounting frame), two 1/2 inch bolts, two nylon washers and a 7/16 inch or adjustable wrench. Note: Remove protective covers from tabs of side burner
Insert the side burner tabs in the slots of the frame(1). Slip washers on the bolts and insert the bolts as shown(2). Tighten bolts with wrench.
(1)(2)
Check that all burner valves are off
You will need: burner control knobs.
Valves are shipped in the OFF position, but you should check to be sure that they are turned OFF. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off. Proceed to the next step. If they do turn continue turning them clockwise until they stop, then they are off. Proceed to the next step.
C050.a |