Weber 500 LX owner manual Install Flavorizer Bars and Cooking Grates, Install the bottom tray

Page 16

Step 15

Install Flavorizer Bars and Cooking Grates

You will need: five Flavorizer Bars and two cooking grates.

Set the Flavorizer Bars side to side in the cooking box. Figure 17.

Step 16

Install the bottom tray

You will need: bottom tray, catch pan holder, catch pan and one drip pan.

Figure 17

Set the cooking grates onto the ledges in the cooking box with the rounded side up. Figure 18.

Finger grip on front

Front side of catch

edge of bottom tray

pan holder

Figure 19

Hook the ends of the catch pan holder into the hole in the bottom tray. Figure 20. The front of the catch pan holder must be on the same side as the finger grip of the bottom tray.

Finger grip

Figure 20

Slide the bottom tray onto the mounting rails under the cooking box with finger grip toward you. Figure 21.

mCAUTION: Do not line bottom tray with aluminum foil.

Figure 18It can cause grease fires by trapping the grease and not allowing grease to flow into the catch pan.

Bottom tray

Figure 21

Put the foil drip pan into the catch pan.

Slide the catch pan into the catch pan holder with its finger grip towards you.

16

Image 16
Contents Spirit 500 LX Series MDANGER MWARNINGS LP GAS Units onlyWarranty Patents and Trademarks Contents For Installation in Canada Gas supply testingGeneral Instructions StorageCheck package contents AssemblyStep Check contents of hardware packs Assemble wheel frame Assemble top frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install manifold bracket Install frame connectorInstall gas supply General Specifications for PipingGas line piping Typical natural gas supply installation. FigureTest connections Check that all burner valves are off Install igniterConnect flexible hose to manifold Check for gas leaks MWARNING Do not ignite burners while leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesMCAUTION Do not line bottom tray with aluminum foil Install Lid Add tool holders, control panel and burner control knobsComplete accessory installation Lighting To ExtinguishManual Lighting Periodic Cleaning CookingStorage and/or Nonuse PreheatingAnnual Maintenance Inspection and Cleaning of the Weber Spider Stopper GuardsGeneral Maintenance Main Burner Cleaning ProcedureMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations Burner does not light, or flame is low in High position MCAUTION Do not line the bottom tray with aluminum foilPage 11-12 Parts List Page Page Final Word Thanks