Jenn-Air 209240 Pressure Testing, Conversion to LP GAS, Regulator, Illustration E Illustration D

Page 4

PRESSURE TESTING

The maximum gas supply pressure for the appliance pres- sure regulator suppliedon this appliance is t 4" W.C. The test pressure for checking this appliance pressure regulator must be at least 6" W.C. for Natural Gas, and at least 11" W.C, for

LP, It is shipped from the factory set for Natural Gas at 5" _/.C.

This appliance and its individual shutoff valve must be dis- connectedfrom the gas supplypiping system duringany pres-

sure testing of that system at test pressures in excess of ½" PSIG (3.5 k Pa).

This appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2"PSIG (3.5 k Pa).

APPLIANCE PRESSURE REGULATOR CONVERSION (See Illustration "D")

If this is a Maxitrol Appliance Pressure Regulator, follow in- structionin illustrationI.f it isa Harper-WymanAppliance Pres-

sure Regulator converted to LP by inserting a coin into the slot in the cap of the appliance pressure regulator and turn countemlockwiseto loosen. Reverse (invert) cap, push down and turnclockwise to lock in place. When finished, the mark- ing "LP" should be visible in the center well of the cap.

CONVERSION TO LP GAS:

This appliance is shipped from the factory equipped for use with Natural Gas. To convert it from Natural Gas for use with LP gas, perform steps 1 through 4.

1.Remove natural gas orifice hoods. Install color coded ori-

rice hoods supplied,located in a pack attached to the outer

plenum area of this appliance.

(See Illustration "E", Below, and LP Gas Conversion

instructions page 6.)

2. Invert cap in convertible appliance pressure regulator (ifso equipped) located at entrance to gas manifold.

3.Adjust air shutters on individual burners for proper flame appearance.

4.Adjust low flame setting at each burner by turning adjust- ment screw in center of valve stem.

To make these conversion adjustments follow the instruc- tions and illustrations ("A" through "E" page 3-4).

CAUTION

Test all joints for gas leaks with a soap and water solution I or other accepted leak detection means. Never test for gas eaks with an open fame.

This appliance is shipped from the factory with orifice hoods drilledfor use with Natural Gas. To convert from Natural Gas to LP, apply a ½" open-end wrench to hex section of orifice hood. TURN COUNTERCLOCKWISE TO REMOVE. Save

the Natural Gas orifice hoods just removed from this appli- ance for future use. Install colorcoded orifice hoods supplied.

MAXlTROLAPPMANCE PRESSURE

_ PLY.D.ODWsN_su(SEEARE Lp GAS CONVERSION INSTRUCTIONS ABOVE AND

REGULATOR

_T"_}I=S_E_uTO PAGE 6.) TURN CLOCKWISE TO INSTALL. Hold dimension

,,_LP

REPLPACEINNOAP. specified in illustration"E'.

_p

I

_

RNGERPRESSURE

1/2" OPEN END

_--

_

_TQREMDVEPIN

_

c0.vE,v-

 

 

/

L.J !

-- i

 

TURN

 

 

 

 

 

 

CLOCKWISE

 

I

TURN _.L_'_

TO TIGHTEN

Inversioof pin m ybemos ea

hed

I

COUNTERCLOCKWISE

_

\

byplacingcapona flathorizontsilyaccomplisasurface,

 

 

 

 

 

shown, applyingfingerpressureto thepinfor

I

TO REMOVE

 

ORIFICE HOOD

removaandld replacement.

 

 

 

 

 

ILLUSTRATION "E"

ILLUSTRATION "D"

_)

HARPERAPPLIANCE-WYMAN

" _"

PRESSURE

_,

/_j/

CONTROL SE'n'INGS

The size and type of cookware and the amount and type of

food being cooked will influence the setting needed for best

cooking results.The setting indicated shouldserve as a guide while you become familiar with your cooktop.

begin a cooking operation. Then reduce to a lower setting to

settinUs thg,e HI flame setting to quickly bring foods to a boilz or,to

continue cooking. Novet lea ve food unattended over a Hi fla_e

ing operation. Food will not cook any _

_,_

faster when a HI flame setting is used

 

than that isneeded to maintain a gentle

-_._

 

 

 

boil. Remember, water boils at the same

(/_

",

 

_

 

_

t mperature whe

boiling gently or

f_-

_1

 

Med setting isusedthero continue a cook-_'

 

NaturalSetting

LPSetting

vigorously.

 

 

 

 

Thereversibcapislable

eledeither=LP"or"Natandi"seasilyrecognized Use Lo setting to keep food at serving

 

 

 

bytheraisedcentercoinslot(for atural)orthecenterwell(forLP).

temperatures without further oking. _

_iI

 

 

ALTERNATE

ILLUSTRATION "D"

You may find that some cooking may L_

_ -_-j'

 

 

 

4 take place if the cookware is covered.

Image 4
Contents IiUENN Installingcabinetryoveryour JENN-AIRGRILL Instructionsto Installer4THICK Flame Cabinetsabove Cooking TOPLOW Flame Adjustment AIR Shutter AdjustmentIllustration C Pressure Testing Conversion to LP GASRegulator Illustration E Illustration DII11111Illlllllll1 Model CVG4200 , CVG4280 Series Model To Convert Appliance for USE with Natural GASSeries Required Adjustments AT Time of Installation Installation Code