Installingcabinetryoveryour JENN-AIRGRILL

*A =30" (76.2 cm) minimum vertical clearance between cookingsurfaceand constructionabovetheappliance. The undersideof combustiblematerial or metal cabi- netsabovethe cookingtopmustbeprotectedwithflame retardantmillboardnot less than 1/_,,(0.635cm) thick.

,-1=13" (33.02 cm) maximumdepth of cabinets installed above cookingtop.

,wl

_I/4"THICK FLAME

* AB --_ RETARDANT

k	,_,--....	_	MILLBOARD
	[ __ __

-- --

*Toeliminateassociatedpotentiahlazardsuchas reachingover openflames,avoiduseof cabinetsabovecooktopfor storage space,

CABINETSABOVE COOKING TOP

Maximumdepthof cabinetsinstalledabovecookingtop is 13 inches,

Anon-combustiblematerialmustbe installedontheunder- side of a cabinetlocatedabovethe cookingsurfaceof this appliance.

iNSTALLATIONOF APPLIANCE

Followaccompanyingductingnstructionsarefully,

Thisapplianceisdesignedto alwaysbe ventedoutdoors,

The CountertopCutout,Cabinet FrontCutout and Duct Openingshouldbe preparedaccordingto the Illustration on page1 and2.

The installationf this appliancemustconformwithlocal codesor,inthe absenceof localcodes,withthe latestedi- tion of the National Fuel Gas Code, ANSI Z223.1 USA or current CAN/CGA-B149INSTALLATIONCODE.

The electricalsupplyrequiredis 110/120-Volt,A.C., 15amp,

60Hz. This applianceis equippedwith a groundedtype powercord.A groundedoutletmustbe provided.It is rec- ommended,for conveniencethi,s outletbe locatedin the

area shownin the shadedillustration(seefig. 2).

Thisappliancewh, eninstalled,mustbeelectricallygrounded

in accordancewithlocalcodesor, in the absenceof local

codes,withthelatest editionofthe NationalElectricalCode

ANCanSIa/dianElectricaNFPANo.70 USAl Coderpartcurr1e.ntCSASTANDARDC22.1

Warrantyis voidon JENN-AIRequipmentinstalledother

CAUTION

thanas recommendedby manufacturerR. ecommended

wall capsand transitions must be utilizedfor proper op- erationand installation,

_ _ ._ _,,_ _ ,

T-_---_ i_ I

Fig.2

CabinetBottom

WARNING

THIS APPLIANCE IS EQUIPPED WITH A THREE-

PRONGGROUNDINGPLUGFORYOURPROTECTION

AGAINST SHOCK HAZARD AND SHOULD BE ELECTRICALGROUNDING INSTRUCTIONS PLUGGEDDIRECTLYINTOA PROPERLYGROUNDED

RECEPTACLE. DO NOT CUT OR REMOVE THE

GROUNDING PRONG FROM THIS PLUG.

Install a manualshutoff valve in an accessible location in the gas line external to this appliancefor the purpose of

turning on or shuttingoff gas to the appliance.

Makethe gas connectionto the inlet of the appliancepres- sure regulatoron this appliancewith a 1/2"malepipethread. Use an approvedpipe joint compound resistantto the ac- tion of LP gas at pipe connections.Test all joints for gas leakswitha soapandwatersolutionorotheracceptedleak

detectionmeans. Never test for gas leaks with an open flame.

INSTRUCTIONSTO INSTALLER

1, Chamferallexposededgesofdecorativlaminateto pra. vent damagefromchipping.

2. Radiuscornersof cutoutandfile toinsuresmoothedges

and preventcornercracking.

3. Rough edges, inside corners which have not been

roundedand forcedfit can contributeto crackingof the countertop laminate.

4. Countertopmustbe supportedwithin3" of cutout.

Minimumhorizontalclearancebetweenthe edgeof the applianceand combustibleconstructionextendingfrom

the cookingsurfaceto 18" (45.7 cm)above the cooking surfaceis:

0" (0 cm) at rear

2" (5.08cm) at sides

This is not the recommendedclearance,but minimum

allowableclearance. (See pageone, "Side Clearance" and belowfor recommendedclearance.)

	/	_,
18"
(45.7cml	/ _/_'_	_ _'_ _"
-"
_	/	DOUBLEBAYSHOWN,
	8 cm'_)	DOUBLEBAYSHOWN,
Min. Clearance		TOP BURNERS

Recomme6n"(1d 5.24cm)for OMITFEDON maximurnventilatpieonrformanceSINGLEBAY.