Step 5
With the help of a friend, set the unit upright. Try to minimize stress on the legs of the grill.
Step 6
Insert wire wood rack (curved ends pointed down) into holes on bracket near bottom of legs then tighten all bolts until secure.
Step 7
Attach hood stops to the outside back of the body using M6 x 12 bolts. Thread bolts into welded nuts and tighten until secure.
Step 8
curved end
pointed down
Attach the hinges (with the spine side out) to the outside back of the body using
M6 x 12 bolts. Thread bolts into welded nuts but do not tighten at this point. Place lid over the body and attach hinges to the outside back of the lid using M6 x 12 bolts. Thread bolts into welded nuts. Tighten all hinge bolts on lid and body until secure.
Step 9
Attach handle to the lid using two M5 x 75 bolts, flat washers, spacers, spring washers and M5 x 4 hex nuts. The heads of the bolts should be slightly recessed into the wooden handle when fully tightened.
Hood
Hinge
Hood
Stop
M6 X 12
bolts
M5 x 75 | Flat | Spacer | Spring | M5 X 4 | |
bolts | washer | washer | hex nut | ||
|
5