Brinkmann Stainless Steel 4 Burner Gas Grill Filling the LP GAS Cylinder, Hose and Regulator

Page 7

WARNING

FILLING THE LP GAS CYLINDER:

•Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder.

•New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank.

•DO NOT allow the cylinder to be filled beyond 80% capacity. Over-filled tanks can create a dangerous condition. Over-filled tanks can build-up pressure and cause the relief valve to expel propane gas vapors. The vapor is combustible and if it comes in contact with a spark source or flame an explosion causing severe burns, bodily harm, or death could occur.

•Always use a protective cylinder cap when grill is not connected to cylinder.

•If you exchange a cylinder with a qualified exchange program, be sure the cylinder has a Type 1 valve and an over-filling prevention device (OPD).

INSTALLING THE LP GAS CYLINDER ONTO THE GRILL:

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Place the cylinder into the tank holder in the bottom of cabinet.

3. Orient the cylinder such that the valve opening faces the side table, and so that the hose is not kinked or damaged.

4. Lift tank lock wire to secure cylinder into tank holder.

5. Attach or detach regulator to the LP gas cylinder only

 

Tank Holder

 

when cylinder is at rest in tank holder.

 

 

 

HOSE AND REGULATOR:

Your grill is equipped with a Type 1 connection device with the following features:

1. The system will not allow gas flow from the cylinder until a positive connection to the valve has been made.

Note: The cylinder valve must be turned off before any connection is made or removed.

Tank Lock Wire

2.A thermal device that will shut off the gas flow if the device is subject to temperatures above 240°F to 300°F (115°C to 150°C). If this should happen, remove the entire regulator assembly and dispose of properly. A replacement regulator

assembly can be purchased by contacting customer service at 800-527-0717. The cause of the excessive heat should be determined and corrected before using your grill again.

3. A regulator flow limiting device, when activated, restricts the flow of gas to 10 cubic feet per hour. If the flow limiting device is activated, perform Regulator Resetting Procedure .

REGULATOR RESETTING PROCEDURE

1.Turn burner control knobs to "OFF", turn off the cylinder valve and disconnect regulator from LP gas tank. Wait approximately two minutes.

2.Reattach regulator and slowly turn cylinder valve back on. The flow limiting device will now be reset.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Aviso Para EL Instalador Important Safety Table of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Hose and Regulator Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Filling the LP GAS CylinderConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderWhen to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Turning OFF the Grill Controlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillRotisserie Cooking Grilling to Proper Temperature CleanlinessHelpful Hints Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHeat Distribution Plates Cooking GrillsTransporting and Storage Before Storing Your Grill Trouble ShootingFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Parts List Assembly InstructionsPage Step Press plastic feet onto bottom of left side cart legs Wheel Leg Hubcap Wheel axle Washer Bolt Step Grill Body Assembly Left Side Table Front Panel Right Side Table Step Step Brinkmann 8401 Assembled Peligro Importantes Advertencias DE SeguridadÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Manguera Y Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoProcedimiento DE Reposición DEL Regulador Conexión DE LA Manguera Y Regulador Cuándo Realizar UNA Prueba DE Detección DE Fugas Pruebas DE Detección DE FugasVerificación DE Ausencia DE Fugas ¡PRECAUCIÓN Lista DE Verificación Preliminar AL EncendidoEncendido DE LAS Hornillas Principales Instrucciones DE EncendidoEncendido DE LAS Hornillas Principales CON UN Cerillo Apagado DE LA Parrilla CuidadoControl DE LAS Llamaradas Operación DE LA ParrillaPreparación DE LA Parrilla Para Usarla POR Primera VEZ Precalentamiento DE LA ParrillaCocción Estilo Rotisserie Cocinar a LA Parrilla a LA Temperatura Apropiada LimpiezaRecomendaciones Útiles INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Limpieza Y MantenimientoTransporte Y Almacenaje Continuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS HornillasRejillas Para Cocinar Placas DE Distribución DEL CalorAntes DE Guardar LA Parrilla Identificación Y Corrección DE ProblemasPreguntas Frecuentes Preguntas Frecuentes LA Bolsa DE Partes Incluirá LO Siguiente Contenido DE LA Bolsa DE PartesLista DE Partes Instrucciones DE ArmadoPage Paso Paso Tapas de Ruedas Pierna Bujes Pernos del Eje de las Arandela Paso Conjunto Del Cuerpo De la Parrilla Plateadas Advertencia Soportes Brinkmann 8401 Armada Warranty

Stainless Steel 4 Burner Gas Grill specifications

The Brinkmann Stainless Steel 4 Burner Gas Grill is a remarkable outdoor cooking appliance designed for those who love to grill. This grill combines durability, style, and performance, making it a popular choice for barbecues, family gatherings, and outdoor entertaining.

One of the main features of this grill is its four powerful burners, which deliver a total output of up to 48,000 BTUs. This allows for even heat distribution across the cooking surface, enabling you to grill a variety of foods simultaneously. The stainless steel construction ensures longevity and resistance to weather elements, while also providing a sleek, modern appearance that complements any patio or backyard setup.

The grill includes a spacious cooking area of approximately 660 square inches, offering ample space to cook for large groups. The primary cooking surface is made of cast iron grates, which not only retain heat well but also create perfect sear marks on your food. Additionally, the grill features a porcelain-enameled warming rack that keeps food warm without overcooking, enhancing your grilling experience.

Brinkmann has integrated advanced technologies to simplify the grilling process. The electronic ignition system allows for quick and easy start-ups, eliminating the hassle of matches or lighter fluid. The adjustable burners provide precise control over heat settings, accommodating different cooking methods, whether you're searing steaks or slow-cooking ribs.

Safety and convenience are prioritized in the design, with a built-in thermometer that accurately monitors cooking temperatures, ensuring your food is cooked to perfection. The grill also includes side shelves for additional preparation space and convenient hooks for tools, keeping everything organized while you cook.

Maintenance is straightforward, thanks to the removable grease tray that collects excess fat and drippings, reducing the risk of flare-ups. The grill's stainless steel exterior is easy to clean, and regular maintenance helps to prolong its life.

In conclusion, the Brinkmann Stainless Steel 4 Burner Gas Grill is more than just a cooking appliance; it is designed for grilling enthusiasts who appreciate efficiency, style, and functionality. With its robust features and innovative technologies, this grill is sure to elevate your outdoor cooking experience, making every barbecue a delicious success.
Top Page Image Contents