Brinkmann Stainless Steel 4 Burner Gas Grill Connecting Hose and Regulator to AN LP GAS Cylinder

Page 8

WARNING

•Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

WARNING

The pressure regulator and hose assembly supplied with your gas grill must be used.

•DO NOT attempt to connect grill, as purchased for LP (propane) gas, to any other fuel supply source such as a natural gas line.

•DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill. Replacement pressure regulator/hose assembly must be part No 155-2200-0, which can be obtained by contacting customer service at 800-527-0717.

•DO NOT attempt to adjust or repair the regulator. The regulator is designed to operate at a maximum output pressure of 11 inches of water column (2.74 kPa).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your grill. Only the manufacturer's supplied replacement should be used.

WARNING

CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER

•Ensure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and follow all warnings on the LP cylinder.

CONNECTING HOSE AND REGULATOR

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Check that the grill’s burner control knobs are in the "OFF" positions.

3.Remove the protective plastic cap from the cylinder valve and the connection device.

4.Hold regulator and insert the nipple of connection device into the LP cylinder valve outlet. Ensure that the device is centered properly.

5.Turn the large coupling nut clockwise by hand and tighten to a full stop. Take care not to cross thread the coupling nut onto the cylinder valve. Do not over-tighten the knob onto the valve. Do not use tools to tighten connection.

Note: If you are unable to make the connection, repeat Steps 4 and 5.

6.Check that the hose does not contain kinks, does not contact sharp edges, and does not contact surfaces that may become hot during use.

7.Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Aviso Para EL Instalador Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Installing the LP GAS Cylinder Onto the Grill Regulator Resetting ProcedureFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Turning OFF the Grill Operating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Helpful Hints CleanlinessGrilling to Proper Temperature Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCETransporting and Storage Cooking GrillsHeat Distribution Plates Trouble Shooting Before Storing Your GrillFrequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions Parts ListPage Step Press plastic feet onto bottom of left side cart legs Wheel Leg Hubcap Wheel axle Washer Bolt Step Grill Body Assembly Left Side Table Front Panel Right Side Table Step Step Brinkmann 8401 Assembled Importantes Advertencias DE Seguridad PeligroÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Procedimiento DE Reposición DEL Regulador Llenado DEL Cilindro DE GAS DE Propano LíquidoManguera Y Regulador Conexión DE LA Manguera Y Regulador Verificación DE Ausencia DE Fugas Pruebas DE Detección DE FugasCuándo Realizar UNA Prueba DE Detección DE Fugas Lista DE Verificación Preliminar AL Encendido ¡PRECAUCIÓNEncendido DE LAS Hornillas Principales CON UN Cerillo Instrucciones DE EncendidoEncendido DE LAS Hornillas Principales Cuidado Apagado DE LA ParrillaOperación DE LA Parrilla Preparación DE LA Parrilla Para Usarla POR Primera VEZPrecalentamiento DE LA Parrilla Control DE LAS LlamaradasCocción Estilo Rotisserie Recomendaciones Útiles LimpiezaCocinar a LA Parrilla a LA Temperatura Apropiada Limpieza Y Mantenimiento INSTALACIÓN/MANTENIMIENTO DE LAS HornillasContinuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Rejillas Para CocinarPlacas DE Distribución DEL Calor Transporte Y AlmacenajeIdentificación Y Corrección DE Problemas Antes DE Guardar LA ParrillaPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes LA Bolsa DE Partes Incluirá LO SiguienteInstrucciones DE Armado Lista DE PartesPage Paso Paso Tapas de Ruedas Pierna Bujes Pernos del Eje de las Arandela Paso Conjunto Del Cuerpo De la Parrilla Plateadas Advertencia Soportes Brinkmann 8401 Armada Warranty

Stainless Steel 4 Burner Gas Grill specifications

The Brinkmann Stainless Steel 4 Burner Gas Grill is a remarkable outdoor cooking appliance designed for those who love to grill. This grill combines durability, style, and performance, making it a popular choice for barbecues, family gatherings, and outdoor entertaining.

One of the main features of this grill is its four powerful burners, which deliver a total output of up to 48,000 BTUs. This allows for even heat distribution across the cooking surface, enabling you to grill a variety of foods simultaneously. The stainless steel construction ensures longevity and resistance to weather elements, while also providing a sleek, modern appearance that complements any patio or backyard setup.

The grill includes a spacious cooking area of approximately 660 square inches, offering ample space to cook for large groups. The primary cooking surface is made of cast iron grates, which not only retain heat well but also create perfect sear marks on your food. Additionally, the grill features a porcelain-enameled warming rack that keeps food warm without overcooking, enhancing your grilling experience.

Brinkmann has integrated advanced technologies to simplify the grilling process. The electronic ignition system allows for quick and easy start-ups, eliminating the hassle of matches or lighter fluid. The adjustable burners provide precise control over heat settings, accommodating different cooking methods, whether you're searing steaks or slow-cooking ribs.

Safety and convenience are prioritized in the design, with a built-in thermometer that accurately monitors cooking temperatures, ensuring your food is cooked to perfection. The grill also includes side shelves for additional preparation space and convenient hooks for tools, keeping everything organized while you cook.

Maintenance is straightforward, thanks to the removable grease tray that collects excess fat and drippings, reducing the risk of flare-ups. The grill's stainless steel exterior is easy to clean, and regular maintenance helps to prolong its life.

In conclusion, the Brinkmann Stainless Steel 4 Burner Gas Grill is more than just a cooking appliance; it is designed for grilling enthusiasts who appreciate efficiency, style, and functionality. With its robust features and innovative technologies, this grill is sure to elevate your outdoor cooking experience, making every barbecue a delicious success.
Top Page Image Contents