Brinkmann ProSeries 7751 Match Lighting the Rotisserie Burner, Lighting the Side Burner

Page 12

LIGHTING THE ROTISSERIE BURNER:

1.Open grill hood before lighting rotisserie burner.

2.Make sure control knob is in the "OFF" position.

3.Push and turn control knob to HIGH and continue to push knob in for 2 to 3 seconds to light burner.

4. Once burner is lit, continue to push knob in for 30 seconds.

5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.To turn off, turn control knob clockwise until it locks in the "OFF" position.

IMPORTANT: DO NOT use back rotisserie burner when main burners are in use.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

MATCH LIGHTING THE ROTISSERIE BURNER:

1.Open grill hood before lighting rotisserie burner.

2.Make sure control knob is in the "OFF" position.

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the lower edge of burner.

4.Push and turn the control knob to the "HIGH" position. Continue to push in control knob for 3-5 seconds while holding match under burner.

5.If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

LIGHTING THE SIDE BURNER:

1.Open lid before lighting side burner.

2.Make sure control knob is in the "OFF" position.

3.Push and turn control knob to HIGH and continue to push knob in for 2 to 3 seconds to light burner.

4.If ignition does NOT occur in 5 seconds, turn control knob to OFF, wait 5 minutes to allow gas to dissipate

and repeat lighting procedure.

5.To turn off, turn control knob clockwise until it locks in OFF position.

Note: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

11

Image 12

Contents Aviso Para EL Instalador Important Safety Table of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Installing the LP GAS Cylinder Onto the Grill Regulator Resetting ProcedureFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorLeak Testing When to Perform a Leak TestChecking for Leaks PRE-START Check List Lighting Instructions Lighting the Main BurnersMatch Lighting the Main Burners Lighting the Rotisserie Burner Match Lighting the Rotisserie BurnerLighting the Side Burner Match Lighting the Side Burner Turning OFF the GrillOperating the Grill Breaking in Your GrillPreheating the Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerCleanliness Grilling to Proper TemperatureHelpful Hints Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCECooking Grills Heat Distribution PlatesTransporting and Storage Trouble Shooting Before Storing Your GrillFrequently Asked Questions Frequently Asked Questions Assembly Instructions Parts ListPage Parts BAG Contents Step Igniter Module Electrode Wire Battery Compartment Step ProSeries 7751 Assembled Importantes Advertencias DE Seguridad PeligroÍndice Advertencias Generales Información DE Instalación Especificaciones DEL Cilindro Llenado DEL Cilindro DE GAS DE Propano Líquido Manguera Y ReguladorProcedimiento DE Reposición DEL Regulador Conexión DE LA Manguera Y Regulador Pruebas DE Detección DE Fugas Cuándo Realizar UNA Prueba DE Detección DE FugasVerificación DE Ausencia DE Fugas Lista DE Verificación Preliminar AL Encendido Instrucciones DE Encendido Encendido DE LAS Hornillas PrincipalesEncendido DE LAS Hornillas Principales CON UN Cerillo Encendido DE LA Hornilla DEL Asador Estilo Rotisserie Encendido DE LA Hornilla LateralEncendido DE LA Hornilla Lateral CON UN Cerillo Apagado DE LA ParrillaOperación DE LA Parrilla Preparación DE LA Parrilla Para Usarla POR Primera VEZPrecalentamiento DE LA Parrilla Control DE LAS LlamaradasCocción Estilo Rotisserie LA Hornilla LateralLimpieza Cocinar a LA Parrilla a LA Temperatura ApropiadaRecomendaciones Útiles Limpieza Y Mantenimiento INSTALACIÓN/MANTENIMIENTO DE LAS HornillasContinuacion DE INSTALACIÓN/MANTENIMIENTO DE LAS Hornillas Rejillas Para CocinarPlacas DE Distribución DEL Calor Transporte Y AlmacenajeIdentificación Y Corrección DE Problemas Antes DE Guardar LA ParrillaPreguntas Frecuentes Preguntas Frecuentes Contenido DE LA Bolsa DE Partes Instrucciones DE Armado Page Paso Módulo de Encendedor Alambre de Electrodo Paso ProSeries 7751 Armada Warranty