Brinkmann 2600 Series owner manual Igniter Button Cap

Page 25

OFF

HIGH

in owner’s manual before lighting.

2.Open lid before lighting burner.

3.Make sure all control knobs are in the OFF position.

4.Select the burner to be lit. Push and turn the control knob of that burner to HIGH.

OFF

HIGH

200 300

400

100

° F

50 500

seconds to light burner.

6.If burner does NOT ignite immediately, turn control knob to OFF, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

OFF

HIGH

use electronic igniter for lighting each burner.

8.Refer to owner’s manual for match lighting procedure.

9.For assistance, call 1-800-527-0717.

10.To turn off, turn control knobs clockwise until it locks in OFF position.

OFF

HIGH

INSTRUCTIONS:

1.

Follow Steps

 

1-3 in GRILL

 

LIGHTING

 

INSTRUCTIONS.

2.

Push and turn

 

SIDE BURNER

 

control knob to

 

HIGH.

Note: When performing Step 9, Lift grill body from front and rear panels to avoid injury to hands and fingers.

Step 9

With the help of a friend, place grill body assembly on grill cart. Grill body will rest between upper side sections of cart. Align front edge of grill body assembly with front edges of cart frame legs. Secure using four M6 X12mm bolts. At this point, fully tighten six bolts holding back panel from Step 4.

LOW

LOW

LOW

 

FOR OUTDOOR USE ONLY

LOW

3. Follow Steps

5-10 in GRILL

LIGHTING

INSTRUCTIONS.

Igniter Button Cap

Note: To install battery, unscrew igniter button cap. Insert battery with positive end towards button. Replace igniter button cap.

GRILL LIGHTING INSTRUCTIONS:

 

1.

Read and follow all warnings and instructions

 

5.

Press the electronic igniter and hold for 3-5

7.

Repeat Steps 4-6 for lighting each burner. Always

 

 

 

in owner’s manual before lighting.

 

 

seconds to light burner.

 

 

use electronic igniter for lighting each burner.

 

 

2.

Open lid before lighting burner.

 

6.

If burner does NOT ignite immediately, turn control

8.

Refer to owner’s manual for match lighting procedure.

3.

Make sure all control knobs are in the OFF position.

 

knob to OFF, wait 5 minutes to allow gas to

9.

For assistance, call 1-800-527-0717.

4.

Select the burner to be lit. Push and turn the control

 

dissipate and repeat lighting procedure.

10.

To turn off, turn control knobs clockwise until it locks

 

 

 

knob of that burner to HIGH.

 

 

 

 

 

in OFF position.

 

OFF

OFF

 

 

 

OFF

 

OFF

HIGH

HIGH

 

 

HIGH

 

 

HIGH

 

LOW

LOW

FOR OUTDOOR USE ONLY

LOW

 

LOW

Alignment

SIDE BURNER LIGHTING INSTRUCTIONS:

1.Follow Steps 1-3 in GRILL LIGHTING INSTRUCTIONS.

2.Push and turn

SIDE BURNER control knob to HIGH.

3.Follow Steps

5-10 in GRILL LIGHTING INSTRUCTIONS.

24

Image 25
Contents Gas Stainless Steel Outdoor Grill For Your Safety Important SafetyPage Cylinder Specifications Installation InformationPage Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Side Burner Lighting the Side BurnerTurning OFF the Grill Breaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingBefore Storing Your Grill Transporting and StorageBurner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHardware CastingsProblem Possible Causes Burner will not light Trouble ShootingGrilling to Proper Temperature CleanlinessHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts Card Contents Step Attach back cart panel by using six M6 X 60mm bolts Tank Tray Assembly Step Spring Pin Grease Tray Bracket Igniter Button Cap Step Side Table Screw Holes Tool Drawer Step Pro Series 2600 Assembled Accessories Gallon PAN & Basket SET Warranty