4. Troubleshooting and Maintenance
Error Display | Cause | Remedy |
| Temperature taken is higher than 42.2°C | Check the integrity of the probe cover and take a new |
| (108.0°F). | temperature measurement. |
|
|
|
| Temperature taken is lower than 34.0°C | Make sure the probe cover is clean and take a new |
| (93.2°F). | temperature measurement. |
|
|
|
| Device can not be powered on to the ready | Change to a new battery. |
| stage. | (Refer to section 4.3) |
|
|
|
4.2Maintenance
•Please check the device if damaged after it is dropped. If unsure, please contact the OMRON retail outlet or distributor for having the device checked.
•The probe is the most delicate part of the unit. Use care when cleaning the Infrared sensor to avoid damage.
•Do not store the unit in the following types of places. Doing so may damage the unit.
-Wet locations.
-Locations with high heat and humidity or those that are exposed to direct sunlight. Areas close to heating equipment, dusty locations, or environments where there are high salt concentrations in the air.
-Locations where the unit will be subjected to leaning over, falling, shock or vibration.
-Pharmaceutical storage areas or locations where corrosive gases are present.
12