Invacare 3650 manual General Guidelines

Page 13

SECTION 1—GENERAL GUIDELINES

Operation

DANGER

Keep hair and body away from suction guard when pump is running.

The causes, symptoms, and effects of hyperthermia may be described as follows: Hyperthermia occurs when the internal temperature of the body reaches a level several degrees above the normal body temperature of 98.6° F. The symptoms of hyperthermia include an increase in the internal temperature of the body, dizziness, lethargy, drowsiness, and fainting. The effects of hyperthermia include:

Failure to perceive heat

Failure to recognize the need to exit the spa or hot tub

Unawareness of impending hazard

Fetal damage in pregnant women

Physical inability to exit the spa or hot tub

Unconsciousness resulting in the danger of drowning

The use of alcohol, drugs, or medication can greatly increase the risk of fatal hyperthermia.

NEVER operate whirlpool without water level above the whirlpool jets. Severe pump damage will result.

DO NOT operate this unit without the guard over the (water intake) suction fitting. The guard is a safety device that reduces the potential hazard of hair or body entrapment.

To reduce the risk of injury, DO NOT permit children or infirm persons to use this unit unless they are supervised at all times.

Recommended length of a bath is 5 to 10 minutes. However, if you become nauseous or dizzy or develop a headache, get out at once and cool down. Get medical attention if symptoms persist. Also, check with a physician before using this unit again.

Anyone under a doctorʹs supervision, pregnant, or with poor health, should check with a physician before using this unit.

Part No 1118387

13

Side Entry Whirlpool Tub

Image 13
Contents Side Entry Whirlpool Tub Accessories Warning Table of Contents Limited Warranty Special Notes MaintenanceCabinet Door 3600XL Label LocationModel Typical Product ParametersModels 3600 and 3600XL FeaturesModel Installation Important Safety Instructions General Guidelines Plumbing ElectricalDisinfecting Maintenance and InspectionGeneral Guidelines About Installation Parts InstallationParts Information Preparing the Work AreaPreparing the Work Area Securing Tub Securing TubElectrical and Plumbing Hook-up Locations on the Tub Electrical InstallationParts and Installation Electrical Installation Plumbing Installation Plumbing Installation Post Installation ChecklistOverview Operating InstructionsDisinfecting the Tub Using the Closed Loop System Opening the Tub Door Opening/Closing the Tub DoorClosing the Tub Door Tub Operation Water Temperature SettingFilling Tub Operating Shower/Massage WandFilling Tub HydromassageSafety Inspection Checklists Safety INSPECTION/ TroubleshootingCleaning the Door Seal Gasket CleaningCleaning Your Tub Removing Soap Film and Hard Water DepositsRequired OZ Heavy Duty Cleaning ProcedureCalibrating the Disinfectant Flow Meter Safety INSPECTION/TROUBLESHOOTING Symptoms Faults Solution TroubleshootingMaintenance Record Side Entry Whirlpool Tub USA Limited Warranty
Related manuals
Manual 36 pages 42.54 Kb