Setup

Info: Before initial operation, clean the nebulizer cup assembly following the instructions given in MAINTENANCE/Cleaning the Nebulizer Cup.

WARNING: Ensure that the nebulizer compressor is unplugged during setup.

1.Before each use, inspect the compressor and nebulizer cup assembly for damage or wear; replace as needed.

2.Place the compressor on a table or other flat stable surface (not on the floor), in an area that is clean and dust-free. Be sure you can easily reach the controls when seated.

3.Open the nebulizer medication cup: Twist the cap counter-clockwise until it stops, then lift cap off.

4.Pour the prescribed medication into the nebulizer

	medication cup. Do not fill with more than 5 ml per
	treatment.	cap
	5. Install cap on cup. Turn clockwise	cap
	5. Install cap on cup. Turn clockwise	cup
	to tighten.	cup
	to tighten.
		install cap
		on cup

6.If using the mouthpiece for treatment, proceed to step 7. If using a mask, install the bottom part of the mask directly onto the top of the nebulizer medication cup cap as shown at right. Proceed to step 9.

7.Insert mouthpiece into large end of T adapter.

JB0112-070-INS-LAB-RevB14

mask cap

install mask

on cap

Tadapter mouthpiece

assemble

mouthpiece

and T adapter