Fitting the Mask |
|
|
1 | 2 | 3 |
English
Turn the dial, so that the forehead support is fully extended.
4
Unfasten the Velcro®, pull the upper headgear straps evenly until they are comfortable and firm, and reattach the Velcro.
Hold the mask over your nose and pull the headgear over your head.
5
Repeat step 4 with the lower headgear straps.
Bringing the lower straps below your ears, connect the headgear clip to the the mask frame.
6
Connect the main air tubing to the swivel. Then connect the free end of the air tubing to your flow generator and turn the flow generator on.
7 | 8 |
Lie down in your sleeping position. Adjust the dial until the mask is evenly positioned on your face. It should be comfortable, with a satisfactory seal. Adjust the headgear straps if necessary.
The fitted mask is shown above.
Removing the Mask Disconnect one of the headgear clips and pull the mask and headgear up over your head.
3