PROFESSIONAL HAIR CLIPPER INSTRUCTION MANUAL
READ ALL INSTRUCTIONS BEFORE USING AND STORE FOR SAFEKEEPING.
Part Name
Top blade
Bottom blade 
Blade lever 
On/off switch
ACCESSORIES
Attachment Comb #1 Attachment Comb #2
Attachment Comb #3 Attachment Comb #4
BLADE ALIGNMENT
•Your clippers were carefully examined to ensure that the blades were oiled and aligned before leaving the factory.
•Blades must be realigned if they have been removed for cleaning or replacement.
•To realign the blades, each upper blade tip should be in line with the corresponding lower blade tip.
(The bottom blade’s teeth tips should be approximately 1.2mm below the top blade’s teeth tips.)
1.2mm
•If blade alignment is incorrect, add a few drops of oil to the blades, switch on clipper for a few seconds, switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is aligned.
•To change blade, use Phillips screw driver to loosen 2 screws.
•Remove blade and replace with new blade.
•Align top blade then place bottom blade over top blade and insert screws and tighten slightly.
•Align bottom blade as explained in “BLADE ALIGNMENT” & tighten screws further to secure bottom blade in place.
Blade Cover | Extra Blade |
Comb Scissors Oil Brush
OIL
•To keep your clipper in peak condition, the blades should be oiled every few uses.
•Do not use hair oil, grease, oil mixed with kerosene or any other solvent. The solvent will evaporate and leave a thick layer of oil which may slow down the blade’s motion.
20800_IM.indd 2
2013/03/05 10:32:08 AM