Invacare 440 manual Activating a Mechanical Emergency Release, Primary Emergency Release

Page 18

SECTION 3—OPERATION

Activating a Mechanical Emergency Release

Primary Emergency Release

NOTE: For this procedure, refer to

FIGURE 3.5.

NOTE: This procedure will bring the boom down if the hand control is not functioning properly.

To activate the primary emergency release, insert a pen into the hole labeled Emergency Down on the control box.

Secondary Emergency Release

NOTE: For this procedure, refer to

FIGURE 3.6.

NOTE: All patient lift actuators are equipped with a mechanical emergency release. The mechanical release will enable the actuator to retract without power.

NOTE: Use the primary emergency release first before using the secondary emergency release procedure. This procedure should only be used if the primary emergency release procedure is not functioning or is unreachable.

Control Box

Emergency Down

Hole

FIGURE 3.5 Primary Emergency Release

Actuator

Column

Pull Up Red

Tag for

Emergency

Lowering

NOTE: The lift MUST be under a load for the	FIGURE 3.6 Secondary Emergency Release
NOTE: The lift MUST be under a load for the
mechanical release to function.

To activate the secondary emergency release, pull up on the RED emergency grip and pull down on the boom at the same time.

Reliant™ 440

18

Part No 1141431

Image 18

Contents Reliant Patient Lift Symbol Legend Accessories WarningTable of Contents Using the Patient Lift AS a Standing AID Special Notes MeaningLabel Location Typical Product Parameters Reliant 440 Patient LiftGeneral Guidelines Weight LimitationUsing the Sling Assembling the LiftOperating the Lift Lifting the PatientPerforming Maintenance Transferring the PatientAssembly Assembling the Patient LiftAssembling the Patient Lift Attaching the Kneepad Attaching the KneepadAttaching the Battery Attaching the BatteryMounting the Battery Charger Mounting the Battery ChargerOperating the Patient Lift OperationIntroduction Locking/Unlocking the Rear CastersUsing the Emergency Stop Raising/Lowering the Patient LiftClosing/Opening Leg Base Activating a Mechanical Emergency Release Primary Emergency ReleaseCharging the Battery Charging the BatteryTransferring from Lifting PreparationLifting the Patient Moving the Patient Lifting the PatientTransferring to Transferring Patient To WheelchairTransferring Patient to Bed Transferring Patient To WheelchairTransferring Patient to Bed Transferring Patient to Commode Using the Patient Lift AS a Standing AID Standing ProcedureDo not lift the patient Troubleshooting Symptoms Faults SolutionInspect/Adjust Initially MaintenanceSafety Inspection Checklists Institutional Inspect/Adjust MonthlyIn-Home Inspect/Adjust Every Six Months Care and Maintenance of Stand-Up Lift Cleaning the Sling and the LiftDetecting Wear and Damage This procedure Must be performed by a qualified technician Replacing Electric ActuatorMaintaining the Base Adjustment Replacing Electric ActuatorReplacing the Casters Front CasterRear Caster Limited Warranty USA