Omron rs2 Using the Memory Function, To View the Readings Stored in Memory, Troubleshooting

3.4 Using the Memory Function

The unit automatically stores up to 30 sets of measurement values (blood pressure and pulse rate). If the memory is full, the monitor will delete the oldest readings.

To View the Readings Stored in Memory

1.Press the button.

The Memory number appears for a second before the pulse rate is displayed. The newest set is numbered “1”.

Note: If there are no measurements results stored in the memory, the screen to the right is displayed.

2.Press the button repeatedly to view the readings stored in memory.

To Delete All the Values Stored in Memory

When the memory symbol ( ) appears, first press the button. Then while holding it down, press the START/STOP button simultaneously for about 2 - 3 seconds.

First Second

Note: You cannot partially delete the stored readings.

4.Troubleshooting and Maintenance

4.1The Icons and Error Messages

Error Display	Cause	Remedy
		Remove the wrist cuff. Wait
		2 - 3 minutes and then take
	Irregular heartbeats	another measurement.
	are detected.	Repeat the steps in section
		3.3. If this error continues to
		appear, contact your doctor.
	The batteries are	You should replace them with
Blink		new ones ahead of time.
	low.
		Refer to section 2.1.
	The batteries are	You should replace them with
Lit		new ones at once.
	exhausted.
		Refer to section 2.1.
	Wrist cuff not	Apply the wrist cuff correctly.
	applied correctly.	Refer to section 3.1.
		Repeat Measurement while
	Movement during	remaining still and refraining
		from talking during the
	measurement.
		measurement.
		Refer to section 3.3.
		Apply the wrist cuff correctly
	Wrist cuff not	and repeat measurement
	applied correctly, or	while remaining still and
	movement during	refraining from talking during
	measurement.	the measurement.
		Refer to section 3.1 and 3.3.
	Device error.	Contact your OMRON retail
		outlet or distributor.

Note: The irregular heartbeat symbol ( ) may also be displayed with error messages.

4.2 Troubleshooting

Problem	Cause	Remedy
	The wrist cuff is not	Measure while in the
	at heart level.	correct posture.
		Refer to section 3.2.
	The cuff is not	Wrap the cuff correctly.
	wrapped snugly
The reading is		Refer to section 3.1.
	around the wrist.
extremely low
	The arms and	Relax and try taking the
(or high).
	shoulders are	measurement again.
	tense.	Refer to section 3.3.
	Movement or	Remain still and do not
	talking during	talk during Measurement.
	measurement.	Refer to section 3.3.
Wrist cuff pressure	Air is leaking from	Consult your OMRON
does not rise.	the wrist cuff.	retail outlet or distributor.
		Apply the cuff correctly so
Wrist cuff deflates	The wrist cuff is	that it is firmly wrapped
too soon.	loose.	around the wrist. Refer to
		section 3.1.
		Blood pressure readings
		constantly vary with time
The blood pressure is different		of day and how relaxed
each time. The reading is		you are. Take several
extremely low (or high).		deep breaths and try to
		remain relaxed before
		taking a measurement.
The unit loses		Replace the batteries with
power during	The batteries are
measurement.		new ones.
	exhausted.
		Refer to section 2.1.
Nothing happens
when you press	The batteries have	Insert the batteries with
the buttons.	been inserted	the correct (+/-) polarity.
	incorrectly.	Refer to section 2.1.
	• Press the START/STOP button and repeat
	measurement.
Other problems.	• If the problem continues, try replacing the
	batteries with new ones.
	If this still does not solve the problem, contact
	your OMRON retail outlet or distributor.

4.3 Maintenance

To protect your unit from damage, please observe the following:

•Do not subject the main unit and the cuff to extreme temperatures, humidity, moisture or direct sunlight.

•Do not disassemble the unit.

•Do not subject the unit to strong shocks or vibrations (for example, dropping the unit on the floor).

•Do not use volatile liquids to clean the main unit. •Do not wash the cuff or immerse it in water. •Do not use petrol, thinners or similar solvents to clean the cuff.

•Do not carry out repairs of any kind yourself. If a defect occurs, consult your OMRON retail outlet or distributor as mentioned on the packaging.

•The unit should be cleaned with a soft, dry cloth. •Use a soft, moistened cloth and soap to clean the cuff.

•Keep the unit in its storage case when not in use.

•Fold the cuff into the storage case.

Do not store the unit in the following situations:

•If the unit is wet.

•Locations exposed to extreme temperatures, humidity, direct sunlight, dust or corrosive vapours.

•Locations exposed to vibrations, shocks or where it will be at an angle.

Calibration and Service

•The accuracy of this blood pressure monitor has been carefully tested and is designed for a long service life.

•It is generally recommended to have the unit inspected every two years to ensure correct functioning and accuracy. Please consult your authorised OMRON dealer or the OMRON Customer Service at the address given on the packaging or attached literature.

5. Technical Data

Product Description	Wrist Blood Pressure Monitor
Model	OMRON RS2 (HEM-6121-E)
Display	LCD Digital Display
Measurement Method	Oscillometric method
Measurement Range	Pressure: 0 to 299 mmHg
	Pulse: 40 to 180/min.
Accuracy	Pressure: ±3 mmHg
	Pulse: ±5% of display reading
Inflation	Automatic inflation by pump
Deflation	Automatic rapid deflation
Memory	30 Measurements
Power Source	2 “AAA” alkaline (LR03) batteries 1.5V
Battery Life	Approx. 300 measurements with new
	alkaline batteries at a room temperature of
	23°C
Applied Part	= Type B
Protection Against	Internally powered ME equipment
Electric Shock
Operating temperature/	+10 to +40°C / Maximum: 30 to 85% RH
Humidity
Storage temperature/	-20 to +60°C / Maximum: 10 to 95% RH /
Humidity	700 to 1060hPa
Console Weight	Approximately 101g without batteries
Outer Dimensions	Approximately 78 (w) mm x 60 (h) mm x
	21 (d) mm (without the wrist cuff)
Measurable	Approximately 13.5 to 21.5 cm
circumference
Cuff Material	Nylon and polyester
Package Content	Main unit, storage case, battery set,
	instruction manual, guarantee card

Note: Subject to technical modification without prior notice.

•This device fulfils the provisions of EC directive 93/42/EEC (Medical Device Directive).

•This blood pressure monitor is designed according to the European Standard EN1060, Non-invasive sphygmomanometers Part 1: General Requirements and Part 3: Supplementary requirements for electromechanical blood pressure measuring systems.

•This OMRON product is produced under the strict quality system of OMRON HEALTHCARE Co. Ltd., Japan. The Core component for OMRON blood pressure monitors, which is the Pressure Sensor, is produced in Japan.

Important information regarding Electro Magnetic Compatibility (EMC)

With the increased number of electronic devices such as PC’s and mobile (cellular) telephones, medical devices in use may be susceptible to electromagnetic interference from other devices. Electromagnetic interference may result in incorrect operation of the medical device and create a potentially unsafe situation. Medical devices should also not interfere with other devices.

In order to regulate the requirements for EMC (Electro Magnetic Compatibility) with the aim to prevent unsafe product situations, the EN60601-1-2:2007 standard has been implemented. This standard defines the levels of immunity to electromagnetic interferences as well as maximum levels of electromagnetic emissions for medical devices.

This medical device manufactured by OMRON HEALTHCARE conforms to this EN60601-1-2:2007 standard for both immunity and emissions.

Nevertheless, special precautions need to be observed:

•Do not use mobile (cellular) telephones and other devices, which generate strong electrical or electromagnetic fields, near the medical device. This may result in incorrect operation of the unit and create a potentially unsafe situation. Recommendation is to keep a minimum distance of 7 m. Verify correct operation of the device in case the distance is shorter.

Further documentation in accordance with EN60601-1-2:2007 is available at OMRON HEALTHCARE EUROPE at the address mentioned in this instruction manual.

Documentation is also available at www.omron-healthcare.com.

Correct Disposal of This Product

(Waste Electrical & Electronic Equipment)

This marking shown on the product or its

literature, indicates that it should not be disposed of, with other household wastes at the

end of its working life.

To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this product from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources.

Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can return this item for environmentally safe recycling.

Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.

Manufacturer	OMRON HEALTHCARE Co., Ltd.
	53, Kunotsubo, Terado-cho, Muko, Kyoto,
	617-0002 JAPAN
EU-representative	OMRON HEALTHCARE EUROPE B.V.
	Scorpius 33, 2132 LR Hoofddorp
	THE NETHERLANDS
	www.omron-healthcare.com
Production facility	OMRON (DALIAN) CO., LTD.
	Dalian, CHINA
Subsidiary	OMRON HEALTHCARE UK LTD.
	Opal Drive, Fox Milne, Milton Keynes, MK15 0DG
	U.K.
	OMRON MEDIZINTECHNIK
	HANDELSGESELLSCHAFT mbH
	John-Deere-Str. 81a, 68163 Mannheim, GERMANY
	www.omron-medizintechnik.de
	OMRON SANTÉ FRANCE SAS
	14, rue de Lisbonne, 93561
	Rosny-sous-Bois Cedex, FRANCE
	Made in China