LifeSource UA-774 manual About Average Reading, About Memory

NUMBER OF MEASUREMENTS STORED IN MEMORY

AVERAGE

TAKING YOUR BLOOD PRESSURE

NOTE: If you wish to stop inflation at any time, press either START button again.

NOTE: The maximum cuff pressure is set at 280 mmHg. If it reaches 280 mmHg, the auto exhaust will be triggered and cuff pressure will deflate to 0.

6.When the inflation is complete, the deflation starts automat- ically and the ❤ blinks, indicating that the measurement is in progress. Once the pulse is detected, the symbol flashes with each pulse beat.

NOTE: If an appropriate pressure is not obtained, the device automatically starts to inflate again.

7.When the measurement is complete, the systolic

and diastolic pressure readings and pulse rate are displayed and stored. See Page E-9 for more details about the memory function.

The cuff deflates and the monitor automatically shuts off after 60 seconds, or you can turn it off by pressing either START button.

8.Remove cuff and make note of your blood pressure and pulse rate on the Blood Pressure Record chart (see Page E-15), indicating the date and time of measurement.

Additional logbook charts can be downloaded and printed for free at www.LifeSourceOnline.com. or www.autocontrol.com.

E-8 LifeSource Health Line (Toll-Free): 1-888-726-9966

ABOUT AVERAGE READING

The UA-774 provides an average blood pressure reading based on the measurements stored in memory. When the monitor is turned on, the average blood pressure reading will appear with the number of measurements stored in memory flashing three times. The START 1 button will provide the average reading for User 1 and the START 2 button will provide the average reading for User 2.

ABOUT MEMORY

The memory function on the UA-774 blood pressure monitor is designed for two people. For each START button, the monitor can store up to 30 readings in memory. To keep track of previous measurements accurately, we recommend that you use the same START button each time you take a blood pressure reading.

To recall previous measurements in memory, press and hold the START 1 or START 2 button. Your average blood pressure reading will appear with the number of measurements taken flashing three times. Release the button after the display switches to the memory index number (see illustration on right).

The previous measurements are displayed from most recent to oldest. When viewing previous measurements, you will see the "M" symbol appear on the upper left corner of this display. You can stop measurements by pressing either START button again.

NOTE: Memory will be lost if batteries become low or are removed.

In Canada (Toll-Free): 1-800-463-5414 E-9