Omron 637IT instruction manual Left or right wrist measurement, Alarm, Auto memory

•If you push the SETTING button while the power is turned off, the Setting Screen is displayed in the order shown in the picture.

•You can select the setting or set the date and time with the

buttons.

• To finish the setting, push the ON/OFF button.

Automatic Memory Setting	Position Sensor Setting	Measuring (Wrist) Setting
(Refer to Page 14.)	(Refer to Page 15.)	(Refer to Page 15.)

Alarm Setting (Refer to Page 15.)

Reset Settings	All Memory Erasure	Time Setting
(Refer to Page 16.)	(Refer to Page 16.)	(Refer to Page 16.)

Position sensor	English
The position sensor of your OMRON 637IT can be switched ON or OFF. In

the factory preset the position sensor is enabled. If the position sensor is switched ON you can choose to have the optimal wrist height supported by an acoustic sound (SIGNAL ON or OFF).

Position Sensor Screen	Position Sensor OFF	Position Sensor ON and
	Screen	SIGNAL OFF Screen

Left or right wrist measurement

Normally blood pressure is measured on the left wrist (factory preset). With your OMRON 637IT you can choose to use the monitor either on your left or right wrist. It is recommended to use the same wrist when for optimal comparisons of your blood pressure fluctuations.

Measuring (Wrist) Screen Measuring (Wrist) Right Wrist Screen

Alarm

Your blood pressure monitor has the possibility to set an alarm twice a day. The alarm function can be used to monitor your blood pressure at the same time every day or as a reminder for pill intake.

Auto memory

You can either enable (ON) or disable (OFF) the memory function of your blood pressure. When the auto memory function is switched off the measure- ment will not be stored. When using your OMRON 637IT monitor with more than one person it is recommended to disable the auto memory function. The auto memory function mode is ON when you purchased your OMRON 637IT (factory preset).

14

Automatic Memory

Screen

Automatic Memory

OFF Screen

The alarm will sound for 2 minutes. By pushing the O/I button the alarm will stop. The alarm will not sound when the blood pressure monitor is used (e.g. for measuring or graph display) at the moment the alarm is set.

You can set the requested hour by pushing (				) when flashing. Press SET to lock the hour and pro-
ceed with the minutes. By pushing the (			) you can set the minutes. Press SET to confirm and to
proceed. Push either (	) to enable (	) or disable (			) the alarm. Press SET to lock the settings.

Alarm Screen	Screen of indicating that
	the alarm is sounding
	15