MEASURING YOUR BLOOD PRESSURE
•The Blood pressure monitor automatically carries out pressurization until the pressure that is best suited to the blood pressure measurement is reached.
•When the unit determines that an adequate pressure is not obtained, the unit starts pressurization again.
•Wait a while after the completion of pressurization. Then, the 
mark comes on and the unit automatically starts measuring your blood pressures.
•When the unit detects your pulse, the 
mark fl ashes on and off, then the unit gives your blood pressure value on the lower section of the display.
•Upon completion of measurement, the buzzer sounds and the unit automatically exhausts air from the cuff. Then, the Systolic blood pressure/Diastolic blood pressure/pulse will appear on display.
•As long as the unit functions correctly, the blood pressure and the pulse rate for the result with the record of the time and date are automatically stored in memory as one set of data.
•Up to 60 sets of measurement data can be stored in the memory. If you measure your blood pressure when 60 sets of measurements have already been stored in memory, the earliest set of measurements is automatically deleted to make way for the new measurements.
English