Omron Healthcare NE-C28 instruction manual Troubleshooting Tips, Problem Cause Solution

TROUBLESHOOTING TIPS

PROBLEM	CAUSE	SOLUTION
		Turn the power switch off.
No power on unit when the	The device is not plugged	Plug the power plug into an
power switch is turned on.	into an electrical outlet.
		electrical outlet. Turn the
		device on.
	No medication in the	Add the correct amount of
	medication cup. Too much
		medication to the medication
	or too little medication in
		cup.
	the medication cup.
	The baffle is not placed	Make sure the baffle is correctly
		positioned over the nozzle in the
	in the medication cup or
		medication cup.
	incorrectly positioned.
	The nebulizer kit is not	Make sure the nebulizer kit is
	correctly assembled.	correctly assembled and the
		inhalation accessory is correctly
		attached.
No nebulization or low	The nozzle is blocked.	Clean and disinfect the nebulizer
nebulization rate when		kit to remove the blockage.
the power is on.
	The nebulizer kit is tilted	Hold the nebulizer kit correctly.
	at an incorrect angle.	Do not tilt the nebulizer kit so the
		angle of the kit is greater than 45
		degrees.
	The air tube is incorrectly	Make sure the air tube is correctly
	attached.	attached to the compressor and
		the nebulizer kit.
	The air tube is folded or	Make sure the air tube is not folded,
	damaged.	kinked or bent. Inspect the air
	The air tube is blocked.	tube for any damage. Replace the
		air tube if damaged.
	The air filter is dirty.	Replace the air filter with a new
		clean air filter.
The device is	The air filter cover is	Attach the air filter cover correctly.
		Make sure the air filter cover is
abnormally loud.	incorrectly attached.
		not blocked.
The device is very hot.	The ventilation slots are	Do not block the ventilation
		slots located on the sides of the
	blocked.
		compressor. Do not cover the
		compressor with any type of
		cover during use. Place the device
		where the ventilation slots are not
		obstructed during use.

22