ASSEMBLY AND SET-UP
q Charging the Battery
Your electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the battery
prior to use. |
|
|
| |
• | Initial charge time: 12 hours |
| • | Run time: up to 40 minutes |
• | Recharge time: up to 8 hours, |
| • | Average battery life: 250 charge/discharge cycles |
| depending on the level of depletion |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Charger
Port
Charger |
|
Plug | 2 Plug the charger plug into a |
1 Plug the charger port into | |
the port on the scooter. The | wall outlet. |
charger works with the power |
|
switch in either the on or off |
|
position. |
|
qAttaching the Handlebars
1 Insert handlebar assembly | 2 Handlebar assembly should | 3 Once stem is all the way |
into fork. | be all the way in with the collar | down and no more threads |
| covering the threaded portion | on fork are visible, tighten |
| of the fork. Spin the handlebar | two collar bolts with 5 mm |
| stem clockwise down onto the | hexagonal key wrench. |
| fork to ease installation. |
|
q Attaching the Seat
1 Remove the four bolts | 2 Position seat onto frame and | 3 Secure seat with the |
from the frame with the 5 mm | align holes. | four bolts. |
hexagonal key wrench. |
|
|
q Riding Your Scooter
Testing the Brake – To use the brake, squeeze the brake lever to increase the pressure on the brake. The brake lever is fitted with a cable adjuster to compensate for cable stretch and/or to
3
WARNING: Always disconnect your E500S scooter from the charger before cleaning with liquid.
Note: If your charger does not look like the one illustrated, your unit has been supplied with an alternative charger. The specifications and charging procedure would not change.
The charger has a small window with one LED or two LEDs to indicate the charge status. Refer to the illustration on the charger unit for the actual “charging” and “charged” status indications for your model charger.
Chargers have
Be sure to properly align the groove on the charger input plug with the corresponding socket on the case; otherwise, no charging action will occur.
WARNING: Failure to properly tighten the collar bolts may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances.
Note: The cable and wire assembly from the handlebar must be routed as shown in step 1, not wrapped around the steering tube or handlebar. Sharp bends or twisting of the brake cable can cause the brake to malfunction.