BEFORE yOU BEgIN
Remove contents from box. Inspect the contents of the box for scratches in the paint and/or dents that may have occurred during shipping. Because your scooter was partially assembled and packed at the factory, there should not be any problems, even if the box has a few scars or dents.
Grips 
Handlebar
Down tube
Collar clamp
Rear fender/brake
Fork headset locknut
Front fork | Deck |
|
Wheels and wheel bearings
qRequired Tools
5mm
Allen wrench
aSSEmBly INSTRUCTIONS
qDouble Collar Clamp
1 Loosen the collar clamp and | 2 With the front wheel pointed |
slide it upward. With a | straight ahead, the handlebars |
twisting motion, push and “thread” | square to the front wheel and the |
the | Razor logo facing the front, tighten |
bottoms out on the fork headset | the clamp as shown. Tighten each |
lock nut. | bolt securely. |
WaRNINg: DO NOT USE
Razor scooters have been built to certain Razor design specifications. The original equipment supplied at the time of sale was selected on the basis of its compatibility with the frame, fork and all other parts. Certain aftermarket products may or may not be compatible and will void your warranty.
WaRNINg: Failure to properly install and tighten the collar clamp may cause the rider to lose control and fall. If you do not understand these instructions or the concept of “tighten securely” seek the assistance of a qualified mechanic.
Need Help? Visit our website for replacement parts and product support at www.razor.com or call
2