Pride Mobility Quantum 6000Z, Q6 Edge manual Transit Securement System

Page 15

Informational Supplement

15

Transit Securement System

The following components of the transit securement system must be com- pliant to ANSI/RESNA WC/Vol. 4, Section 18/ISO 10542 standards (for- merly SAE J2249) and must be installed according to the manufacturer’s instructions.

„Wheelchair Tie-down and Occupant Restraint System (WTORS)

„4-point power chair tie-down system with an integrated 3-point occupant restraint

„Tie-down end fittings

„WTORS securement points

„Occupant restraint securement points

NOTE: To obtain a copy of ANSI/RESNA WC/Vol. 4, Sections 18 and/or 19 visit http://www.ansi.org.

NOTE: To obtain a copy of ISO 7176-19 or ISO 10542 visit http:// www.iso.org.

www.pridemobility.com

Transit Securement System

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Transit Securement System Table of Contents Introduction Labeling Definitions User Safety InformationProtocols and Procedures See figure Securing the Power ChairSecurement Points on a Quantum 6000Z Securement Points on a Quantum Wtors Recommended Clear Zones for Power Chair-seated Occupants Proper Pelvic Belt Placement Power Chair-anchored Belt Restraint Power Chair Belt Restraint Anchor Transit Securement System Important Points to Remember Informational Supplement Pride Occupied Transit Securement System Declarations Appendix Declarations INFMANU3658
Top Page Image Contents