I V . A S S E M B L Y
To install the seat:
1.Set the trapeze bars to the desired height. To change the trapeze bar height, see V. “Comfort Adjustments.”
2.Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 10.
3.Lower the front extrusion onto the front trapeze bar until the seat locks into place.
4.Flip the seat latch safety down.
WARNING! Make sure the seat latch safety is flipped down before using your power chair.
Power Elevating Seat Installation (Optional)
Your power chair may be equipped with the power elevating seat option. While the seat itself may be any one of the styles offered for this model, the way the seat base attaches to the power base is different.
To install the power seat:
l.Align the seat shaft to the hole in the actuator. See figure 11.
2.Insert the seat shaft into the actuator and push the seat lever forward.
3.Lock the seat into place.
4.Plug the power elevating seat switch cable into the connector on the electronics tray.
Controller Installation
Depending on the various configurations and options you have chosen for your power chair, it may have been shipped without the controller module installed in the armrest.
WARNING! Do not place the controller harness so that it can be pinched in the seat frame or power base frame.
1.Flip up either the right or left armrest.
2.On a contour seat, flip up the armrest and loosen the setscrew. See figure 12.
3.Slide the controller into the armrest.
4.Tighten the setscrew(s) and lower the armrest.
5.Route the controller harness so that it cannot be pinched in the seat hinge.
MANDATORY! Prevent controller harness damage! Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct tie- down points for the controller harness to pre- vent the harness from getting caught in the drive tires, pinched in the seat frame, or dam- aged when passing through doorways.
6.Remove the rear lid to expose the electronics tray.
7.Plug the controller connector into the electronics tray. See figure 7.
8.Secure the controller harness to the armrest receiver with one or more wire ties. See figure 13.
Figure 11. Power Elevating Seat Actuator
CONTROLLER BRACKET
SETSCREW
Figure 12. Controller Installation (Underside of Armrest)
Figure 13. Controller Harness Routing on a Contour Seat
22 | www.pridemobility.com | Quantum Jazzy 1420 Series |