V . C O M F O R T A D J U S T M E N T S
Controller Position
You can move the controller in toward or out away from the armrest, or change the position of the controller for either left- hand or
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
To extend the controller:
1.Flip up the armrest so it is perpendicular to the floor.
2.Loosenthesetscrewonthecontrollerbracket.Seefigure16.
3.Slide the controller into or out of the armrest to the de- sired position.
4.Tighten the setscrew to secure the controller.
To change the controller position:
1.Turn off the power to the controller.
2.Unplug the controller connector(s) from the power base.
3.Cut the wire tie(s) securing the controller cable to the armrest.
4.Flip up the armrest and loosen the setscrew. See figure 16.
5.Slide the controller out of the armrest.
6.Loosen the setscrew in the other armrest.
7.Place the controller in the other armrest.
8.Tighten the setscrews in each armrest.
9.Use a wire tie to secure the controller cable to the armrest.
10.Plug the controller connector(s) into the power base.
NOTE: If your power chair is equipped with a TRU- Balance Seating System, refer to the controller adjust- ment information contained in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different heights.
To raise or lower the foot platform:
1.Remove the hardware from the foot platform bracket. See figure 17.
2.Loosen the foot platform securement nut
3.Raise or lower the foot platform to the desired height.
4.Reinstall the hardware into the foot platform bracket and tighten.
5.Tighten the securement nut.
CONTROLLER BRACKET
SETSCREW
Figure 16. Underside of Armrest
SECUREMENT NUT |
FOOT |
PLATFORM |
BRACKET |
Figure 17. Foot Platform Adjustment
26 | www.pridemobility.com | Jazzy 614 Series |