Pride Mobility 614 2S I . C a R E a N D M a I N T E N a N C E, Care and Maintenance, Temperature

V I I . C A R E A N D M A I N T E N A N C E

CARE AND MAINTENANCE

YourJazzy614Seriesisasophisticatedpowerchair.Likeanymotorizedvehicle,itrequiresroutinemaintenancechecks.Youcan performsomeofthesechecks,butothersrequireassistancefromyourauthorizedPrideProvider.Preventivemaintenanceisvery important.Ifyoufollowthemaintenancechecksinthissectionasscheduled,youcanhelpensurethatyourpowerchairgivesyouyears oftrouble-freeoperation.Ifyouhaveanydoubtastoyourpowerchair’scareoroperation,contactyourauthorizedPrideProvider.

WARNING! Do not service the power chair when the seat is occupied.

Your power chair, like most electrical equipment, is susceptible to damage from the elements.Avoid damp areas of any kind.

WARNING! Direct or prolonged exposure to water or dampness could cause the power chair to malfunction electronically and mechanically. Water can cause electrical components to corrode and the chair's frame to rust. Power chairs should be examined periodically for signs of corrosion caused by water exposure, bodily fluid exposure, or incontinence. Damaged components should be replaced or treated immediately.

Should your power chair come in contact with water:

1.Dry your power chair as thoroughly as possible with a towel.

2.Allow your power chair to sit in a warm, dry place for 12 hours to allow unseen water to evaporate.

3.Check the joystick operation and the brakes before using your power chair again.

4.If any inconsistencies are found, take your power chair to an authorized Pride Provider. Power chairs that are fre- quently exposed to sources of water, such as incontinence, should be inspected often for corrosion and electronic components may need to be replaced frequently.

Temperature

!Some of the parts of your power chair are susceptible to extreme changes in temperature. Always keep your power chair between the temperatures of 18°F (-8°C) and 122°F (50°C).

!In extremely cold temperatures the batteries may freeze. The specific temperature at which they freeze depends on a number of factors, such as battery charge, usage, and composition of the batteries (e.g., AGM or Gel-Cell).

!Temperatures above 122°F (50°C) may cause your power chair to operate at a reduced speed. This reduced speed is a safety feature built into the controller that helps prevent damage to the motor and other electrical components.

General Guidelines

!Avoid knocking or bumping the controller, especially the joystick.

!Avoid prolonged exposure of your power chair to extreme conditions, such as heat, cold, or moisture.

!Keep the controller clean.

!Check all connectors to ensure that they are all tight and secured properly.

!Make sure pneumatic drive tires are inflated to 35 psi (2.4 bar/240 kPa).

WARNING! Make sure your tires are inflated to 35 psi (2.4 bar/240 kPa). Do not underinflate or overinflate your tires. Low pressure may result in loss of control, and overinflated tires may burst. Overinflating tires can cause them to explode.

WARNING! Do not use a high pressure hose to inflate your tires.

!Use a rubber conditioner on the tire sidewalls to help preserve them.

WARNING! Never use a rubber conditioner on the tread area of the tires; doing so may make the tires slippery and cause your power chair to skid.

!All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

32 www.pridemobility.com Jazzy 614 Series