Pentair Section Maintenance, Maintaining the Prowler 720 and 730 Cleaner

9

Section 3

Maintenance

Maintaining the Prowler™ 720 and 730 Cleaner

Clean the Filter Bag after every Cleaning Cycle

1.Unplug the power supply. (Keep the plug away from contact with water.)

2.If the unit is in the pool, gently pull the cleaner toward you using the cable until the handle is within reach. Use the handle (not the cable) to pull the cleaner out of the pool after allowing most of the water to drain from the unit.

3.Lay the unit on its back on a smooth surface, (in order to prevent scratches on the machine body), unlock and remove the bottom lid assembly, see Figure 14, Steps 1 - 4.

4.Remove the filter bag from the support bars, see Step 5, turn it inside out and wash off all the dirt with a garden hose or in a sink. Squeeze the bag gently until the rinse water is clear. If necessary, machine wash the bag using only cold water with NO DETERGENT!

5.Re-install the bag on the support bars with the label in the center of one of the long sides of the bottom lid, see Step 6.

6.Re-install the bottom lid assembly onto the body. Push down on it until all (4) locking tabs snap properly into place.

1

Lock Tabs

2

3

5

6 Label

Figure 14.

Prowler™ 720 and 730 Installation and User’s Guide