Pentair 720, 730 Important Maintenance Tips, In-SeasonStorage, Off-SeasonStorage, Cable Care

Cable Care

The cable may become twisted after a period of use. To correct this condition, simply lock the moveable handle on the top of the cleaner in the opposite diagonal direction. The pool cleaner will now travel in the opposite direction while cleaning your pool and the cable will uncoil. Check the cable periodically for external damage. If the problem persists, use the E-Z Swivel device.

Place the Robot on the ground and unplug the cable from the transformer. With one hand holding the E-Z Swivel, walk away from the Robot, pulling the cable to its full length. The core will rotate inside the cover which will untangle the cable, see Figure 19.

Important Maintenance Tips

1.Shut off and unplug the power supply every time you remove the cleaner from the water.

2.Clean the filter bag after every cycle.

3.Reverse the handle after every cleaning cycle to avoid tangling the cable.

4.Periodically straighten out the floating cable.

5.Replace worn brushes to ensure maximum cleaning performance.

6.Make sure that your pool cleaner positions itself properly on the wall. The machine handle must rest parallel to the water line upon reaching the surface of the water.

7.Save your cleaner's packaging for off-season storage or for shipping the unit to your dealer if service is required.

8.Store the unit and accessories on the caddy.

11

E-Z SWIVEL - Location

Handle Cover

Core

Cable

Assy.

patent pending

Figure 19.

9.Leave your pool cleaner in the water for 15 to 20 minutes after every cleaning cycle.

10.Do not leave your cleaner in direct sunlight when not in use.

11.Never leave the power supply in direct sunlight and avoid leaving it in the rain.

12.Occasionally, you should rinse your cleaner in clean, fresh water. This will lengthen the service life of the drive belts, drive tracks and scrubbing brushes.

In-Season Storage

Do not leave your Prowler™ cleaner in the pool when not in use. Doing so, will reduce the life of your Filter Bag and the Prowler™ cleaner. After removing the Prowler™ cleaner from the pool, you should clean and re-install the Filter Bag. Then, rest the Prowler™ cleaner on its side in a dry shaded area along with its Power Supply and properly coiled Floating Cable.

Off-Season Storage

When the Pool Season is over, you should thoroughly clean the Filter Bag. Make sure that there is no water in the Prowler™ cleaner. Completely untangle and then properly coil the Floating Cable. Your Prowler™ cleaner and Power Supply should be stored in a dry, protected area away from freezing temperatures.

Prowler™ 720 and 730 Installation and User’s Guide