Pentair important safety instructions Operating the Prowler 720 and 730 Cleaners, cont’d

5

Operating the Prowler™ 720 and 730 Cleaners, cont’d.

1.Place the power supply, (transformer), at least ten feet / three meters from the pool as shown in Figure 2. The transformer will supply low voltage to the cleaner.

2.Uncoil the cable as shown in Figure 3.

3.For proper operation, lock the moveable handle diagonally across the top of the cleaner's body. Push down on the handle lock mechanism and slide the handle all the way to the end, (we recommend one slot before the end), then release the lock. The handle will remain fixed in this position. Repeat this process on the other side of the cleaner. Remember, the handle must be fixed diagonally, see Figures 4 and 5.

4.Place the unit in the water. Turn the unit side to side in the water to allow air to escape from the body and then let the cleaner sink to the bottom of the pool, see Figure 6. Then, spread the cable over the surface of the pool as evenly as possible as shown in Figure 2.

5.Plug the cable into the power supply. Make sure the key on the plug exactly corresponds with the key slot on the socket of the power supply, see Figure 7. Plug the power supply into a grounded outlet. Make sure that the electric outlet has been properly grounded, see Figure 8. The light will glow indicating that the system is “ON” and the pool cleaner will start the cleaning cycle. The unit keeps record of the number of cleaning cycles. Onlyanauthorizedservicecentercandisplay the accumulated cleaning cycles. (See details on the next page.)

Figure 7.

Transformer Transformer

PlugSocket

Figure 8.

Figure 2.

Figure 3.

Figure 4.

Handle Lock Mechanism

Figure 5.

Figure 6.

Prowler™ 720 and 730 Installation and User’s Guide