Sunrise Medical S-11 Seat Removal, Seat Fore/Aft Adjustability Figure, Remove Shroud

Page 23

 

 

 

V

I

I

I

.

 

S

e

t

-

u

p

,

 

A

d

j u

s

t

m

e

n t

&

 

U s e

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

E n g l i s h

23

J. SEAT REMOVAL

1.Remove Seat (Figures 17, 18 & 19)

a.Disconnect the joystick power cable in the rear of the chair.

b.To remove the seat: release the safety lock-out pin (Fig. 17), pull up on both release mechanisms (Fig. 18), and tilt the seat forward.

c.Loosen the screws on each side of the front seat mount.

d.Slide the seat backwards and lift off.

e.When replacing the seat into the mounts, ensure you do not pinch your fingers.

2.Seat Fore/Aft Adjustability (Figure 20)

a.Unscrew four bolts underneath the seat that attach the seat to the seat frame.

b.Adjust forward or backward to desired position.

c.Tighten all four bolts.

Always replace the safety lock-out pin to prevent inadvertent release of the seat.

K. SHROUD/FENDER REMOVAL (Figure 21)

The plastic protective shroud can be removed for adjustment or servicing.

1.Remove Shroud

a.Remove the seat (see Section J).

b.Remove the Velcro attached shroud by lifting up.

2.Replace Shroud

Replace shroud by reversing above instructions.

3. Remove Fenders

After removing the shroud, unscrew the two screws holding the fenders in place (Fig. 21).

L. CHECK-OUT

Once the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly.

After the wheelchair has been set up be sure the chair performs to your specified opera- tional settings (see Operating Guide). If the chair does not perform to specifications, turn the wheelchair OFF immediately and reprogram operational specifications using the QTRON- IX Programming Pad (see section B of Operating Guide).

Repeat this procedure until the wheelchair performs to specifications before attempt- ing active use of the wheelchair.

If you have any problems, follow these procedures:

1.Review the Set-up, Adjustment & Use section and Operating Guide to make sure chair was properly prepared.

2.If your problem persists, contact your authorized supplier. If you still have a problem after contacting your authorized supplier, contact Sunrise customer service. See the introduction page for details on how to contact your authorized supplier or Sunrise customer service.

17

18

19

20

21

932108 Rev. C

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Mode d’emploi et garantie For Answers to Your Questions N t r o d u c t i o nIntroduction Sunrise ListensN t s II. Table of ContentsT a b l e o f C o n t e n t s VIII. SET UP, Adjustment & USEQuickie S-11 I . Y o u rIII. Your Chair and ITS Parts IV. NOTICE- Read Before USE Choose the Right Chair & Safety OptionsAdjust Chair to Your Ability T i c e R e a d B e f o r e U s eSources of EMI What is EMI?EMI Electromagnetic Interference What Effect can EMI HAVE?Report ALL Suspected EMI Incidents Immunity LevelController Settings Weight LimitG e n e r a l W a r n i n g s Center of Balance Motor Vehicle SafetyTerrain Street USETo Reduce The Risk Of a Fall Or Tip-Over TransfersReaching or Leaning If YOU Must Reach or LEAN, do SO AT Your OWN RiskRAMPS, Slopes & Sidehills Dressing or Changing ClothesObstacles Driving in ReverseMake sure ramps meet all Building Codes for your area To Reduce the Risk of a FALL, TIP-OVER or Loss of ControlRamps AT Home & Work Wheelchair LiftsEscalators StairsVII. Warnings Components & Options I . W a r n i n g s C o m p o n e n t s & O p t i o n sPositioning Belts ON/OFF SwitchMotor Locks Pneumatic TiresSuspension WiringUpholstery Fabric CHECK-OUT VIII. SET-UP, Adjustment & USETools YOU will Need I I . S e t u p , a d j u s t m e n t & U s e Footplate AdjustmentIntegral Joystick Hanger Adapter OptionalSWING-AWAY Footrests Elevating Legrest OptionalBackrest Armrests AdjustmentSeat Height Adjustment Replace Shroud Seat Fore/Aft Adjustability FigureSeat Removal Remove ShroudQuickie Qtronix Programmer PAD Optional Performance Control SettingsO p e r a t i n g I d e IX. Operating GuideCircuit Breakers Joystick AssemblyEngage Motor Locks O p e r a t i n g G u i d eIntroduction Battery ChargerA t t e r i e s BatteriesAcid Burns Unsealed WET Cell Batteries Connecting Batteries in Battery WellCharging Batteries Disposing of BatteriesM a i n t e n a n c e XI. MaintenanceCleaning Battery MaintenanceFor Answers To Questions Contact your supplier To Repair or Replace a TireMotor Brushes CorrosionCheck Maintenance ChartOrdering Parts I n XII. Wiring DiagramWiring Diagram Detail Integrated Control System I I . S u n r i s e L i m i t e d W a r r a n t y XIII. Sunrise Limited Warranty
Top Page Image Contents